Search: tool boxes > RV Leveling Blocks >
Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The thickness of the tube is not any different as they are both 3 inch diameter, and the spindles are also the same utilizing the same inner diameter bearings, hubs, and seals. The difference in capacity is in the custom bend in the axle that creates…
view full answer...The Dexstar #AM20789 Mini-Mod wheel and the Americana #AM20906 valve stem are indeed compatible with each other, but the center cap you referenced, part #LHCS102-SI60C is compatible with a 3.19 inch wheel pilot hole diameter, and wouldn't work…
view full answer...The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…
view full answer...Generally speaking, trailer jacks are intended primarily to handle vertical loads. However, the Bulldog Square A-Frame Jack #BD195318 that you referenced will typically provide better horizontal (side load) stability than a round tube jack of…
view full answer...The Superwinch S5500 Trailer Winch #SW1455200 mounting bolt holes are separated apart by 3-3/4" on center (see attached photo). Attached is a review video for you to reference as well.
view full answer...EcoHitch does not allow their instruction manuals to be linked, so I cut out and added the most relevant portions of the installation of the EcoHitch Hidden Front Mount Trailer Hitch Receiver #306-X7352. This hitch, which is a confirmed fit for your…
view full answer...I would be happy to help you find the right ball mount for your husbands birthday. You are gong to need to measure the receiver on the end of his F-350 to determine the correct ball mount you need. You will want to measure the inside of the square.…
view full answer...Hey Tony, thanks for reaching out. The Kodiak 13" Hub and Rotor #KHR13858D doies have 5/8" studs but there are a few other things you will want to consider to be sure it will work. Firstly, disc brake parts are brand specific. So the Kodiak…
view full answer...Hello James, thanks for reaching out. Yes, there is an option for the 18K BTU Chill Cube unit that comes with a thermostat that controls both the furnace and the AC. What you will need is the following: - Furrion Chill Cube RV AC w Air Distribution…
view full answer...Hey Dennis, you can definitely replace your current AC units with Chill Cubes but you should note that all of the Chill Cubes are rated at 18k btu. So if you have a roof ducts you'd want the part #FR49TD or if there aren't any ducts you'd…
view full answer...The proper replacement for your Parallax 7300 series converter is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers #PD4645V.
view full answer...The Replacement Heavy Duty Snap-Up Bracket #58392 does not require drilling to install as it basically can set on frame members that are up to 2-1/4 inches in width and uses a set screw to secure instead.
view full answer...Filters
- 8 results
Vehicle Fit