Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
We can get you a ball mount with a longer shaft to help keep your trailer safe. Without knowing the rise or drop you need, or the weight capacity, I can only offer a couple of general recommendations for ball mounts with long shafts. Since you have a…
view full answer...A lot of the older Atwood water heaters have been discontinued, yes. For your replacement I recommend the Atwood RV Water Heater #AT94022 which is a 10 gallon gas/electric unit like you currently have with an automatic pilot. This uses 120V power and…
view full answer...Yes. The Replacement Motor and Gear Head Assembly for HappiJac Truck Camper Jack System #LC182515 is the correct replacement motor for your HappiJac Series 4220 #LC736514. This will replace both the motor and gear head assembly that has been damaged…
view full answer...The standard size lunette ring is 3 inches like the Demco Lunette Ring - Adjustable Channel Mount - 3" Diameter - Black - 25,000 lbs #DM09557-81. The 2-1/2 inch rings will not fit in the adjustable channel mounts where the vast majority of the 3…
view full answer...Assuming your tires are in good shape without any bulges the easiest way to determine if you have a bent spindle is to take a straight edge that is longer than the tire and lay it across the tire parallel with your trailer frame and then measure the…
view full answer...Yep! The 1-7/8" 12pt Thin Walled Socket #ALL643216 does work with the e2 Fastway round bar weight distribution systems. This socket costs considerably less than the Equal-i-zer socket and works just as well so it's what we normally…
view full answer...For a large socket that will fit the 1-7/8 inch nut on ball #19286 you can use #EQ70-00-4800.
view full answer...Part #EQ70-00-4800 is a 1-7/8 inch socket with an outer diameter of around 2-3/8 inches.
view full answer...Since most weight distribution (WD) systems use the same style of shank with the same adjustment hole locations and sizes you should be able to just use the Fastway e2 Weight Distribution Shank #FA92-02-4315 which gives a trunnion system a max drop…
view full answer...The max drop the #FA92-02-4315 that you referenced can do is 8 inches. Since you need right at 6 inches of drop to tow your trailer level this shank would work well for you. I attached a help article link on selecting the correct rise/drop ball mount…
view full answer...The non-threaded portion of the Replacement 2" Ball with Nut For Buyers Products Combination Pintle Hitch #337RB102000 is taller than most hitch balls but it has a diameter compatible with a lot of ball mounts as it's shank diameter is 1-1/4…
view full answer...The nut on a hitch ball with a 1-1/4" diameter shank, like the B&W #BWHB94002, takes an 1-7/8" socket, like #ALL643216 (for use with a 3/4" drive socket wrench) for example. Hitch balls with an 1-1/4" shank require 450 ft/lbs…
view full answer...Filter Your Search
Contact and Help