2017 Keystone Hideout Travel Trailer RV Camera

Since your trailer has the bracket #FRCBRKT-BL that would mean your trailer has the Furrion pre-wiring which is very common for newer RVs. The part #FOS43TASF is a fit for this and would be a really easy install. This gives you a monitor with a 4.3…

Hey James, you can go with a 4k axle leaf spring like the part #e22YR in place of what you have now while it has a slightly higher weight capacity it's not enough that it would create a harsh ride quality. This is a 26 inch long spring though so…

Hey Tom! The MORryde Cushioned 5th Wheel Pin Box is an awesome system and will greatly improve your towing experience. Based on the sticker you have a Lippert 1621 pin box. Also, thank you for providing the GVWR of your 2018 Heartland Pioneer PI287…

The Furrion camera system we have is a closed system and would not be compatible with the in-dash display so you would need to purchase GM's camera system to be able to connect to your display instead of having another monitor. If you do end up…

Since your trailer is not pre-wired to accept a backup camera, the Voyager WiSight 2.0 Wireless Backup Camera System w/ Night Vision for Prewired RV #ASA37YR will not work for you. Instead, you're going to want to take a look at the Voyager…

The Voyager WiSight Wireless RV Backup Camera System #ASA37YR you were looking at is only compatible with the RV Backup Camera #ASA74YRor #WVH100 so this would need to be the camera you already have installed or you would need to replace the camera.…

Hey Rodney, it sounds like you've done your homework! That MoRryde set up you referenced is definitely going to upgrade your Dutchman's suspension and make towing it more comfortable. You'll want to take two measurements before ordering…

Hello Herb, thanks for reaching out. The Furrion Vision S+ Wireless RV Observation System #FR64AD does have a motion detector on the rear camera. You can insert a micro SD memory card in the monitor which allows it to record footage at night. You can…

The most likely cause of the "no signal" error you are receiving with the Furrion Vision S Wireless RV Backup Camera System part #FOS43TASF is due to an interruption on the camera's power wire. Make sure that the camera is receiving…

Thanks for reaching out, i have a couple things for you to do. Let me explain below: *12V PWM Filter for RV Backup Camera Systems - Hardwire #VGR64VR. The newer GMC vehicles use PWM(Pulse With Modulation) in their electrical systems. The Furrion…

The Furrion cameras, like what comes in the part #FOS43TASF that replaced the part you referenced, are only compatible with their specific monitors. If you are looking for a camera system that allows you to use your smartphone as the monitor then I…

Hey Luke! What kind of trailer do you have? Yes, the Furrion Vision S+ Wireless RV Backup System #FR57AD will fit where the old Vision S was. They use the same mounting bracket and wiring so it should be an easy swap. The only thing that isn't…