Replacement Lens for the Taillight Assembly part # A39RB

Question

Question:

I have included a picture of the complete light assembly ST37RB. Circled in yellow is a 90 deg. tab at one end of the lense that does not appear in the discriptive photos of the replacement lens. I need a replacement lens that has the tab. Also I need a license plate bracket to fit behind an ST37RB. Recommendations? Thank you. Best regards,

asked by: Michael W

0

Expert Reply:

For the taillight assembly part # ST37RB that you referenced there are 2 lens. One of them is the part # A39RB that you referenced that covers the front of the assembly.

For the side piece that you referenced you would want the part # A37RB.

expert reply by: Jameson C

0

click to enlarge

Answer 1

As a last resort you could use a ST205/75/R14 part #AM1ST86. I would strongly recommend going to a tire shop and getting your damaged tire replaced, or to just purchase a new one to the correct size that you're already using, as soon as possible.…

view full answer...

Answer 2

The best option we can give you are replacement taillights, which are a good idea as well because you can upgrade to LED lights. These draw much less power and are guaranteed to last for life. If your trailer is over 80 inches wide I recommend the…

view full answer...

Answer 3

I believe I have a solution for you, but the SAE number you listed isn't a reliable way to get a replacement lens. We had a different customer email us a picture of his light and give the same number as you and it turned out he needed the part…

view full answer...

Answer 4

The SAE STIAP2 04 DOT number you provided is a DOT approval number, which states that the lens is compliant with DOT regulations. Because of that, that number isn't typically a good identifier for finding a replacement lens. However, in this…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Replacement Lens for the Taillight Assembly part # A39RB

Products Featured in This Question

Continue Researching