Best Way to Mount Redarc Solar Panel Wind Fairings on a TPO RV Roof
Updated 11/13/2026 | Published 11/12/2026 >
Products Featured in This Question
Question:
What is the best way to mount these Redarc Solar Panel Fairings to a TRP roof? What type of adhesives are recommended? Id rather mount these without drilling into my travel trailer TPO roof.
asked by: Travis
Expert Reply:
Hey Travis! For your TPO roof, I recommend using a TPO-compatible sealant like the Dicor Self-Leveling Lap Sealant # DC94SR. Although the Redarc # RED29VR allow adhesive mounting, TPO can be difficult to bond to reliably, so it is best to use mechanical fasteners to secure the mounts.
Add some butyl tape # DC38SR underneath, then apply the Dicor sealant around the mounting points and over the fasteners to prevent leaks.
What kind of solar setup do you have?
Product Page this Question was Asked From
Redarc Solar Panel Wind Fairing Mounts - Qty 2
- Accessories and Parts
- RV Solar Panels
- Mounting Hardware
- Redarc
more information >
Continue Researching
- Q&A: Can I Operate A Furrion Chill Cube Unit With The Remote Only?
- Q&A: How Cold Can it Be for Furrion Chill Cube Heat Pump to Still Work
- Q&A: Recommended Solar Panel Expansion Kit that Works w/ Go Power GP-PV-200M Solar Panels
- Q&A: Troubleshooting Xantrex Pro XM 1800 Inverter E05 Error Code
- Q&A: Can I Drill Holes On The Top Of The Demco 50-Degree A-Frame Coupler DM15349-52?
- Q&A: Correct Replacement For A MaxxFan 4951KS
- Q&A: Can I Use Both the TorkLift StableLoad and the SuperSprings Super Sway Stops for Hauling Camper?
- Article: Big Truck Big RV
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Towing a Trailer? Let's Talk About Brake Controllers



Travis
11/13/2026
Hi Robin, I'm looking to install a rigid panel 200w solar panel to the roof of my 2020 Geo Pro travel trailer. I'm reluctant to drill into the roof of my trailer. Any other methods to secure the wind fairing mounts without using screws or is screws the only recommended way to install? Thanks!