Center Hub OD for Adding Wheel Spacers to # AKHD-545-35-EZ-K
Updated 09/30/2026 | Published 09/28/2026
Products Featured in This Question
Question:
I am looking at wheel spacers for the AKHD-545-35-EZ-K hubs and was hoping someone could provide the center hole diameter or OD of the center hub on these? e.g., 70.5 mm or 71.5 mm, or...? Thanks!
asked by: Alec
0
Expert Reply:
Hey Alec.
I went out to the warehouse and got some photos for you. I'll attach them below. Looks to me like the OD is 65mm and ID is 49.8mm for # AKHD-545-35-EZ-K.
How much of a spacer are you looking for?
expert reply by:
Trent G
0
Outside Diameter of center hub
(click to enlarge)
(click to enlarge)
Inside Diameter of center hub
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles - 10" - 5 on 4-1/2 - Pre-Greased
- Trailer Hubs and Drums
- Hub with Drum
- EZ Lube
- Pre-Greased
- L68149 / L44649
- Standard Grade
- For 3500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Difference Between Dexter and etrailer Hub/Drum Assembly for 3,500 lb Axles
- Q&A: Surge Brakes for Demco KK260 Tow Dolly
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: What is a #84 Spindle and How Do I Know I Have One On My Trailer?
- Q&A: Comparing the eTrailer and Dexter Electric Trailer Brake Kits
- Q&A: Replacement 10" Electric Brakes For A 2019 nuCamp T@G Trailer
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Q&A: Replacement Hub For Lippert 3,000 lb Axle
- Q&A: Replacement Hub and Drum Kit for a Lippert 3,500 lb Axle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Brakes Not Working? Troubleshooting Guide
- Article: Most Popular Wheel Bearings
Alec
9/29/2026
Thanks Trent! I just had a set of Timbren axles (from eTrailer) put on a small teardrop and needed a little additional offset. I'm looking at 1-inch billet aluminum spacers to finish this install. Sourced a set from another vendor - unless you have something that would fit the 65mm hubs with 5x4.5 bolt pattern...