Replacement Cover for Thule Tracker and Tracker II Foot Pack

Question

Question:

The part # I have is 853-5112 looks like the 753-2149 aware the same?

asked by: Fred

0

Expert Reply:

Yes, cover # 853-7084 will fit the Thule Tracker and Tracker II assemblies including # 753-2149.

expert reply by: Michael H

0

Answer 1

To replace the broken foot base from your Thule Tracker Roof Rack you will just need the part #753-2149. This includes 1 foot base that will install with the track on your original kit.

view full answer...

Answer 2

Hey Kevin, thanks for reaching out! Yes, what you're looking for is the Thule Kit Cover for Fixed Point Roof Racks #TH98SA. Let me know if you have any other questions!

view full answer...

Answer 3

To mount feet and crossbars to your Leer truck cap with the Thule Roof Mounted Top Rack System #THTP54, you will need to select the correct length cross bars. The Thule WingBar Evo Crossbars are available in the following lenghts. 43" #TH711120…

view full answer...

Answer 4

The replacement covers we have for the discontinued Thule Tracker II Foot Pack TH430 include the following: - Replacement Cover #853-7084 - Replacement Endcap #853-3593

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Hi Kassi! I do have a couple options that will fit your 2024 Chevy Colorado WT with 2 wheel drive, but the Timbren Suspension Enhancement System - Rear Axle #T83AV is specifically for the 4 wheel drive models. With that said, you will want one of the…

view full answer...

Answer 11

Thanks for the information Audrey and welcome back! For a weight distribution system that sets up quickly, I recommend the Andersen Weight Distribution Hitch w Sway Control item #AN28VR. The Andersen item #AN28VR uses chains instead of spring bars…

view full answer...

Answer 12

Hey Rick, yes you can use the longer Equalizer shank part #EQ90-02-4500 that you referenced in place of what you have now to get a little more length from your towing setup. While this is longer and would in theory apply more leverage it doesn't…

view full answer...

Replacement Cover for Thule Tracker and Tracker II Foot Pack

Products Featured in This Question

Continue Researching