Hub/Drum and Seal Recommendation for a 1997 Coleman Fleetwood Bayport Camper
Updated 07/25/2014 | Published 07/24/2014
Products Featured in This Question
Question:
My 1997 Coleman fleetwood Bayport popup campers original hub is marked 8-257. The bearings both inner and outer are marked L44649, the races are L44610, and the grease seal is 13194TB. My question is if this hub is the appropriate replacement for a complete brakes change and if the 10-9 seal will work with my popups axle? In addition, if the 8-257-5UC3 hub is a good replacement, would I need to use the supplied 10-9 grease seals that comes with the new hub or would i need to use the 13194 grease seals? I notice that the dimensions are a little different O.D. is a little smaller in the thousandths position, I.D is defenitely smaller. Is it acceptable to use 13194 grease seals with this hub? The grease seal is my only hangup at this point.
asked by: Doug J
Expert Reply:
The Trailer Hub and Drum part # 8-257-5UC3 would be the correct hub to use. You will need to order two of the Grease Seals part # 13194 to use on your spindle instead of the included # 10-9 seals.
Other than that one small detail you would be good to go with these hubs as a replacement on your 1997 Coleman Fleetwood Bayport Camper.
Product Page this Question was Asked From
Dexter Trailer Hub and Drum Assembly for 2,000-lb Axles - 7" - 5 on 4-1/2
- Trailer Hubs and Drums
- Hub with Drum
- Standard
- L44649 / L44649
- Standard Grade
- For 2000 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 12 Inch Wheel
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Continue Researching
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Replacement Coil Springs for a 2021 Ram 1500
- Q&A: Best Replacement for a Dexter 69 - 46 A2 Axle
- Q&A: Replacement Hub and Spindle for Dexter 69-46 Axle
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: What is the Best Grease for Trailer Bearings
- Q&A: Adding Brakes to 1999 Jayco Heritage Glacier with Dexter 2,500 lb Axles
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Availability Of 7" Hub/Drum With L68149 / L44649 Bearings And 5 on 4-1/2" Bolt Pattern
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Tell the Weight Rating of a Trailer Axle