Will SnapPad TJ Trailer Tongue Jack Pad Fit 2018 Airstream Tommy Bahama 27FB Jack

Question

Question:

Just confirming, since wasn’t certain if all trailer jack feet are a standard size, but will this fit on an Airstream trailer jack post? I have a 2018 Tommy Bahama 27’ trailer. Jack post appears to be about 2” in diameter.

asked by: Rick R

0

Expert Reply:

Hey Rick! If your trailer jack has a 2" inner tube and a removable foot the SnapPad TJ Trailer Tongue Jack Pad # SN77VR will fit. We don't have a way of knowing what jack is on your Tommy Bahama 27FB, so I recommend getting a more precise measurement just to be sure.

Any big trips coming up with your Airstream?

expert reply by: Robin H

0

SnapPad TJ Trailer Tongue Jack Pad
(click to enlarge)

Kackie

7/26/2026

Agreed, if the tube measures out, then you're good. No regrets - i feel more stable because the rubber isn't likely to slip. And since the foot and pad are essentially one unit, you don't have to fool around with trying to get enough weight on the tongue for the pad fold around the foot.

Robin H.

7/27/2026

@Kackie that's been our experience as well. The added grip and the fact that it stays attached to the jack foot definitely make setup easier. Thanks for sharing your experience!

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Will SnapPad TJ Trailer Tongue Jack Pad Fit 2018 Airstream Tommy Bahama 27FB Jack

Product Page this Question was Asked From

Continue Researching