Will Grease Cap Plug Part RG04-010 Fit Tie Down Engineering SuperLube Grease Caps
Updated 01/28/2010 | Published 01/25/2010
Question:
Will these fit a sup-r-lube tie down system?
asked by: Greg
0
Expert Reply:
We do not carry the Tie Down Engineering hubs and caps, so I could not check for sure if they would fit the Tie Down Super Lube grease caps.
I did get the measurements for the plugs and they will fit a 1-1/4 inch opening on a grease cap. If the opening for your SuperLube caps is 1-1/4 inch in diameter, then these plugs will fit fine.
expert reply by:
Patrick B
0
Product Page this Question was Asked From
Grease Cap Plug for E-Z Lube Grease Caps - Qty 2
- Accessories and Parts
- Trailer Bearings Races Seals Caps
- Plugs
- TruRyde
more information >
Continue Researching
- Q&A: Bearing Kit that Fits 2023 Grand Design 390rk with 8k Axles
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Caliper Solution for Tie Down Engineering 46304
- Article: Trailer Lighting Requirements
- Q&A: Are Different Sizes For The E-Z Lube Grease Cap Plug Available?
- Q&A: How to Bleed Brakes on Trailer Equipped with Titan Model 10 Hydraulic Brake Actuating Coupler
- Q&A: Lippert Slide Actuator and Motor Assembly Replacement Lippert P/N 1A 041012-24-01
- Article: Trailer Maintenance Schedule
- Q&A: Replacement For Dexter EZ Lube 85-1 Grease Caps
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Replacement Parts for EZ Loader Boat Trailer
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Wiring Diagrams