Looking for Replacement Screen Door Slider Panel for 2019 Winnebago Minnie Winnie 26A
Updated 03/03/2026 | Published 03/02/2026
Question:
re lippert part 239061 slider panel first: does it fit on the door on 2019 wiinnebago minnie winnie 26a? Second: do you bend the new one to fit or take some screws out the frame holding the cross members?
asked by: kevin h
Expert Reply:
Hey Kevin, if the slide panel on your 2019 Winnebago Minni Winnie 26A looks like the part # LC239061 and is 9-3/4 inches in height then yes this would be correct replacement for it. Unlike vehicles RV's don't have super specific replacement part info available so you have to know what you have currently to find replacement most of the time. Generally the easiest way to install this is to flex it a bit so that it will fit into the tracks on the screen door. Did yours get broken?
Product Page this Question was Asked From
Lippert Screen Door Slider Panel with Push-Down Knob Opener - Clear
- RV Door Parts
- Screen Door
- Slides
- Clear
- Lippert
more information >
Continue Researching
- Q&A: Is There Replacement Screen for RV Screen Door?
- Q&A: Looking for RV Door Hinge Assembly
- Q&A: Will A New R32 AC Unit Work With Old R410A Controllers?
- Q&A: Comparing 4.80-12 and 155/70R12 Tire Dimensions
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Replacement Circuit Board For Dometic Atwood Water Heater With Circuit Board 91346
- Q&A: Lippert Smart Jack LC643589 - Is The Button Replaceable?
- Q&A: Correct Slide-Topper Awnings for 153.5" and 83.5" Slide Outs
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: Trailer Wiring Diagrams
- Article: Roadmaster Vehicle Specific Base Plates
- Article: How to Replace or Install an RV Roof Vent
David G.
3/3/2026
This slider panel worked well in our screen door (2016 Northwood Snow River). It’s been some time since I did the replacement, but if I remember correctly, I removed two screws holding the lower track for the slider, removed the old crazed panel and installed the new one. Just like new! Total time involved was probably 15 minutes.