Replacement Leaf Spring Hanger for 2019 Jayco North Point 315RLTS
Updated 02/25/2026 | Published 02/24/2026
Question:
Have a 2019 Jayco North Point 315 RLTS. Has Dexter 8723752. Need to know what leaf spring hanger to buy
asked by: Greg G
Expert Reply:
Hello again Greg, did one of your hangers break? You will need to measure to find the right replacement. Your leaf springs are double eye I'm sure, using 9/16" bolts. That only leaves the height as the unknown. See the diagram below, you need measurement "B" to find a replacement.
If it is 4-1/4" then the # E4139 you looked at will work. If you have a different measurement, add that in the comments I can see if a replacement is available.
(click to enlarge)
Product Page this Question was Asked From
Front/Center/Rear Hanger for Double-Eye Springs - 4-1/4" Tall - 9/16" Bolt Hole
- Trailer Suspension Parts
- Hangers
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- 9/16 Inch Diameter
- 4-1/4 Inch Tall
- Single Axle
- Tandem Axle
- Triple Axle
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: dexter seal 10 36
- Search Results: marine wheel bearing grease
- Q&A: Replacement Bearings and Seal for Dexter 6,000 Pound Axle
- Q&A: Determining Hanger Spacing for Replacement Leaf Springs on Trailer
- Shop: Bearing Kit, 15123/ 25580 Bearings, 10-36 Seal
- Search Results: trailair
- Search Results: axle bearing kit
- Search Results: dexter axle bearing kit
- Shop: Lippert Unitized Oil Seals - ID 2.25" / 3.376" OD for 5,200-lb to 8,000-lb Axles - Qty 2
- Shop: Lippert Road Armor Shock-Absorbing Equalizer Kit - Tandem Axle - 3,500-8,000 lbs
- Search Results: leaf spring shackle
- Q&A: How Do I Figure Out What Equalizer Upgrade Works For My Trailer?
- Video: Review of Dexter Trailer Suspension Parts - HD Upgrade Kit Single Axle Trailer - K71-358-00
- Shop: Lippert Trailer Suspension Wet Shoulder Bolt - 9/16" x 2-13/16" - Qty 4
- Q&A: Which MORryde AllTrek 4000 Equalizers Do I Need for a 36" Wheelbase?
- Search Results: shackle kits
- Shop: MORryde ALLTREK 4000 Shock Absorbing Equalizers for Tandem Axle Trailers - 33" Wheelbase - 8K
- Shop: Dexter Single-Axle Trailer Hanger Kit for 2" Slipper Springs - 5" Front, 6-3/8" Rear
- Shop: Rear Hanger for 3" Wide Slipper Springs - 7-11/16" Tall - 1/2" Bolt Hole
- Video: Hands-On with the MORryde Suspension Upgrade Kit for Tandem Axle Trailers w Correct Track
- Video: Review of Dexter Trailer Bearings Races Seals Caps - Bearings - DX26ER
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Video: Checking Out the Front/Center/Rear Hanger for Double-Eye Springs
- Video: Front/Center/Rear Hanger for Double-Eye Springs: The Breakdown
- Q&A: Looking For Angle Braces For Welding To Inside Of Hangers For Additional Strength
- Q&A: Wet Bolt and Shackle Kit with 2-5/8 inch Shackles for 2018 KZ Durango with Dexter 5,200 lb Axles
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Q&A: Best Suspension Upgrade for 33" Tandem Axles: Road Armor vs Dexter EZ Flex for Ember 22ETS
- Video: A Look at the Power Mountain Tallboy 6 Ton Off-Road Bottle Jack with a Military Cargo Trailer
on Trailer Suspension Parts
Greg G.
2/25/2026
It is 4” tall