Will the Roadmaster Sway Bar part # RM-1139-177 fit a 2013 Ford F-150 Raptor

Question

Question:

Hi, Does this part fit the 2013 ford f-150 raptor super cab? Thanks

asked by: Abdulrahman

0

Expert Reply:

Yes, I spoke with my contact at Roadmaster and he confirmed that the Roadmaster Sway Bar part # RM-1139-177 that you referenced is confirmed to fit your 2013 Ford F-150 Raptor.

expert reply by: Jameson C

0

Answer 1

Hey Steve, thanks for reaching out and providing all of your details! The Timbren Rear Suspension Enhancement System #TFR1504D that fits your 2014 Ford F-150 measures 8-5/8" tall so you really only need the Spacer Kit #T48AV which comes with…

view full answer...

Answer 2

1.25 would actually be 0.05" smaller, so it wouldn't be too big - but the Roadmaster Rear Anti-Sway Bar #RM-1139-177 you're looking at has a bar diameter of 1.13" (1 1/8"). Although it may seem small, it's going to work…

view full answer...

Answer 3

Since a 6 inch lift would be a suspension lift you would be able to install the sway bar part #RM-1139-177 on your 2015 Ford F-150. You will have to use the lift kit adapter as well though, part #RM-590046-00. I confirmed this fit with my contact at…

view full answer...

Answer 4

I checked with Roadmaster and to install rear anti-sway bar #RM-1139-177 on your 2015 Ford F-150 you will need to drill into the frame as you mentioned. You would use the step up method of drilling to get to a 1/2 inch hole (Roadmaster indicated the…

view full answer...

Answer 5

The hangers for the Roadmaster Rear Anti-Sway Bar #RM-1139-177 do not have to be perfectly straight up and down but the closer they are to vertical the better the sway bar will work. I have linked a copy of the installation instructions below that do…

view full answer...

Answer 6

We have what you need. The Roadmaster Rear Anti-Sway Bar part #RM-1139-177 is designed specifically for your 2014 Ford F-150. The sway bar is made of a very strong chromoly steel. It does a great job of keeping your vehicle leveled out side to side…

view full answer...

Answer 7

For an anti-sway bar that is a confirmed fit for your 2015 Ford F-150 I recommend taking a look at the Roadmaster Rear Anti-Sway Bar #RM-1139-177. The bar attaches to your rear axle and chassis, enhancing stability by diminishing the roll that can be…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Will the Roadmaster Sway Bar part # RM-1139-177 fit a 2013 Ford F-150 Raptor

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching