Mounting Hole Spacing For Peterson Thin-Line Identification Light Bar 136-3R
Updated 12/01/2025 | Published 11/02/2025
Question:
The specs say the center to center distance of the mounting holes is 6 15/16”. Is that correct? I have an older but similar light bar and the center to center distance is exactly 6”.
asked by: Brian
0
Expert Reply:
Hello Brian, thanks for reaching out. I went out to our warehouse and measured the Peterson Thin-Line Identification Light Bar # 136-3R. I can confirm the mounting holes are indeed 6-15/16" apart.
expert reply by:
Jesse M
0
Peterson Thin-Line Identification Light Bar
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Peterson Thin-Line Identification Light Bar - Incandescent - Black Steel Base - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Light Bar
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 15-1/2L x 1-3/16W Inch
- Red
- Peterson
more information >
Continue Researching
- Shop: TecNiq Tri Bar Heavy Duty ID Bar - 16.5" - Red Lens
- Shop: Identification Light Bar for Trucks and Trailers - Weatherproof - Incandescent - Red Lens
- Shop: Peterson Thin-Line Identification Light Bar - Incandescent - Black Steel Base - Red Lens
- Shop: TecNiq Tri Bar Heavy Duty ID Bar - 14.5" - Red Lens
- Shop: LED Identification Light Bar for Trailers over 80" Wide - Submersible - 9 Diodes - Red Lens
- Q&A: Availability of Replacement Red Lenses for Light Bar On Utility Trailer
- Q&A: Requirements For Position Of Center 3 Light Bar
- Shop: Custer Trailer LED Clearance Identification Light Bar - Red Lens - 17" Long
- Shop: Peterson LED Identification Light Bar - Submersible - 6 Diodes - Stainless Steel Base - Red Lens
- Q&A: Can 3,500 lb Axle of Trailer Be Upgraded to 5,200 lb Axle
- Q&A: Should I Replace the U-bolts When Replacing the Leaf Springs
- Article: Trailer Lighting Requirements
- Q&A: Can Adapter Plate be Used to Install Bulldog Velocity Series 12K Electric Landing Gear Jack
- Q&A: Replacement Reservoir Tank for Lippert Hydraulic Power Slide Out Unit
- Q&A: Trailer Wiring Harness For A 2023 Audi Q5
- Article: How to Mount a Truck Bed Camper
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Most Popular Wheel Bearings
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
Jesse M.
12/1/2025
Hey Brian, did the 6-15/16" spacing on the Peterson Thin-Line light bar end up matching what you needed? Knowing how that measurement worked out could help others comparing older light bars too.