Replacement Lower Section for Magnetek Power Plus series 6300A Model 6332
Updated 10/30/2025 | Published 10/13/2025
Question:
Replacement Section for AC/DC Power Distribution Panel - 35 Amp Part Number: PD4635V Will this replace the power converter in a Magnetek Power Plus series 6300A Model 6332? It says 32 amps output. Its in a 1992 Winnebago class c motorhome.
asked by: Carl S
0
Expert Reply:
Hey Carl, yes the Replacement Section for AC/DC Power Distribution Panel # PD4635V that you referenced was designed to replace the lower section of your Magnetek Power Plus series 6300A Model 6332. I am not sure where you saw 32 amps as the output though as we have it listed as 35 amps.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Section for AC/DC Power Distribution Panel - 35 Amp
- Accessories and Parts
- RV Power Converter
- Converter Section
- 35 Amp
- Progressive Dynamics
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Magnetek Series 6300A Model 6332 Replacement Converter
- Q&A: Replacement Converter series 6300 Model 6332 On 1981 Coachmen
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Q&A: Replacement Converter for your Magnetek Converter Series 6300 Model 6332
- Q&A: Series 6300A Model 6332 Magnetek Replacement Converter
- Q&A: Replacement Lower Unit for Magnetek 6332 Series 6300
- Q&A: What is the Correct Replacement Converter for Parrallax 7300 Model 7355 Converter
- Article: Spring Towing Readiness Checklist
- Article: Brake Controller Installation: Starting from Scratch
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains
- Article: How to Install Tire Chains
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Wiring Diagrams
Jameson C.
10/30/2025
Hey Carl, how did the replacement with the PD4635V power distribution panel go in your Winnebago? Did it fit and perform the way you expected? Your update could make it easier for others working with older Magnetek panels.