Does Westin HDX Winch Mount Grille Guard Interfere with Cameras and Sensors

Question

Question:

I have a 2025 F350 Lariat trim. Will the Westin HDX Winch Mount Grille Guard with Punch Plate - Black Powder Coated Steel interfere with the camera that’s on the bottom of the Forf emblem or any sensor that may be on the front of the truck?

asked by: Ted R

0

Expert Reply:

Hey Ted, yes the Westin HDX grille guard aprt # W32YC would block the sensors and camera on your 2025 Ford F-350. I wish there was a way around that but since modern truck all have so many sensors these guards do interefere.

expert reply by: Jameson C

0

Answer 1

Hey Willyd, it looks like you have a 7-way round connector which is a bit more rare and for that we only have a 7-way to 4-way adapter like the part #47405. Does your trailer with a 5-way actually use the 5th circuit? If so what is it for?

view full answer...

Answer 2

To be able to determine if your current air lift kit on your 2016 Ford F-250 will be able to be used on your 2019 I will need to know exactly what system you have as there are some slight differences between some Air Lift kits. My recommendation is…

view full answer...

Answer 3

Hi Steve; the Westin HDX Winch Mount Grille Guard with Punch Plate #W32YC will interfere with both the camera and front sensors on your 2024 Ford F-350. I believe you can relocate the sensors but Westin doesn't offer a relocation kit for your…

view full answer...

Answer 4

No, it is not Lori but that's typical. The Blu Technology Stainless Steel Water Hose w/ Quick Connects item #GB24FR has a stainless steel outer sheathing to protect the rubber inner tube that actually carries the water through the hose. The hose…

view full answer...

Answer 5

Hey JD, The Weigh Safe Hitch w/ Built-In Scale for 2.5" Hitch #WS88RR uses hitch pic lock #WS54CR, which has a shear strength capacity of 45,000lbs according to Weigh Safe.

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Does Westin HDX Winch Mount Grille Guard Interfere with Cameras and Sensors

Product Page this Question was Asked From

Continue Researching