What Rear Air Bags and Onboard Air Compressor do I Need for My 2025 GMC Canyon Denali 4X4?

Question

Question:

I'm looking for rear air bag kit for my 2025 GMC Canyon Denali 4X4

asked by: Jeff U

0

Expert Reply:

Hello Jeff,

Congrats on the new Canyon Denali!! What is your favorite new feature?

You’ll want the Air Lift Ride Control Air Helper Springs - Rear Axle # AL59533. They have a 2,000-pound leveling capacity, which is more than enough for the Canyon Denali since that’s higher than its maximum payload capacity.

If you’d like to pair the bags with an onboard air compressor, I recommend the Air Lift WirelessONE Compressor System for Air Helper Springs # AL25980. The # AL25980 is great because it comes with a remote, is Bluetooth compatible, and allows you to monitor the bags from inside the truck without installing any kind of gauge on your dash.

What kind are you planning on hauling that you need the extra support?

expert reply by: Kate F

0

App and Remote for Air Lift Compressor
(click to enlarge)

Jeff U.

8/15/2025

Kate. the price is a little high on F33VV. firestone airbags

Kate F.

8/15/2025

@JeffU I agree, Jeff. I’m not sure why they only offer the full 5,000-lb load-leveling option for the Firestone, it’s overkill for most situations. I like that Air Lift’s setup is better matched to the vehicle. If your truck can’t carry 5,000 lbs, why should you have to pay for air bags that can? It would be nice if Firestone more geared their bags toward the vehicle instead of 5K for all.

Answer 1

Hi Steve; the Air Lift WirelessONE Compressor System for Air Helper Springs #AL25980EZ and #AL25980 are both single path systems and come with a remote and Bluetooth functionality. The main difference is the mounting and the compressor. The…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 12

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

What Rear Air Bags and Onboard Air Compressor do I Need for My 2025 GMC Canyon Denali 4X4?

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching