Does the Mounting Bracket for Peterson 150A Trailer Lights Come in White?

Question

Question:

Can I get this bracket in white? Mounting Bracket for Peterson 150, 152, and 203 Series Clearance or Side Marker Lights

asked by: Nick S

0

Expert Reply:

Hey Nick. The Mounting Bracket for Peterson Clearance and Side Marker Trailer Lights only comes in black item # 150-13 and gray item # 150-09. These brackets work with the Peterson 150A light.

What kind of trailer do you have?

expert reply by: Jerred H

0

Jerred H.

9/2/2025

Hey Nick, did you find a suitable bracket for your trailer lights? If you're still looking for a solution, I'm happy to help.

Answer 1

Hey Mike! We don't have an all-in-one part that comes with the brackets and pigtail so you need to order those parts separately. The #AL91RB and #AL91AB will work with the Mounting Bracket #A91BB and then for a pigtail you can use the Right Angle…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Hey Steven, thanks for all of the info you listed on your Grand Design 310GK! Based on that the correct Lippert SolidStep RV Steps are the #LC791574 that you referenced. This matches your doorway width and is a 4 step like you have as well. Is your…

view full answer...

Answer 10

You will want the Trailer Hub & Drum Assembly - 7,000 lbs Axles - 8 on 6-1/2 - Nev-R-Lube #8-385-81SP or #8-385-82UC3 which also includes the lug nuts and grease cap. Both assemblies include the bearings and there is not a hub that comes without…

view full answer...

Does the Mounting Bracket for Peterson 150A Trailer Lights Come in White?

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching