Replacement Foam and Pads for a Thule Hull-A-Port

Question

Question:

Hi Im looking for replacement foam for tule hull a port j carriers.The bars seem to measure 5 from outside to outside. Thank you

asked by: Matthew R

0

Expert Reply:

Hey Matt. We have quite a few replacement pads and foam pieces for the different models of the Thule Hull-A-Port. I have listed them below:

Replacement Top Tube Pad for Thule Hull-A-Port PRO Kayak Carrier item # 8537418

Replacement 50 mm Arm Pad for Thule Hull-A-Port Kayak Carrier item # 8533019

Replacement Base Pad for Thule Kayak Carriers item # 8535302

Replacement 6" Pad for Thule Roof Mounted Kayak Carriers item # 853-5540

Which model Hull-A-Port do you have?

expert reply by: Jerred H

0

Answer 1

You certainly can get replacement pads for the Thule Hull-A-Port PRO. To replace the bottom tube pad, you will want to use the Thule Replacement 6 Inch Pad #853-5540. For the upper arm's tube pads, you will want #8537418. To replace the bottom…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 7

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Replacement Foam and Pads for a Thule Hull-A-Port

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching