Replacing Lights and Trailer Connector on Boat Trailer Over 80 Inches Wide
Updated 06/19/2014 | Published 06/17/2014 >
Products Featured in This Question
Question:
I have a trailer that is OVER 80inch wide, and I am having trouble with the tail lights that are rusty and corroded. I want to replace them with LED tail lights. My trailer is longer than 25 feet, as well I have 1 side marker per side on my trailer. Do you have kits that I can plug and play to this or do you have a kit to rewire the entire trailer including my 7 pin plug that recently was dragged for 3 hours on the highway? Also I have upright guide on posts from Smith that I just installed prior to my previous trip that are LED and will need to tie into the new light setup. At this time I have surge brakes on the trailer, with disc brakes on BOTH axles.
asked by: Andrew G
Expert Reply:
Although there isn't a specific kit available that addresses all your needs, you can use a light kit designed for an over 80 inch trailer like # TL16RK and modify it so it will work. You'd need some extra wire, # 16-3B-1, an ID light bar for the middle of the rear beam that would tie into the running light circuit, part # MCL70RB, a molded trailer connector, part # H20046 and a junction box, part # 38656.
The install would be pretty straightforward. The molded connector would run to the junction box, and the lighting circuits would continue from there. Keep in mind that the molded connector uses a different color code than what's usually found on trailer wiring. The product page shows the function of each wire color.
I've linked you to a video showing the junction box being installed, and I've also linked you to a trailer wiring help page that you should find helpful.
Product Page this Question was Asked From
Optronics Trailer Light Kit for Trailers over 80" Wide - Submersible - 25' Wiring Harness
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- License Plate
- Marker
- Rectangle
- Surface Mount
- Submersible Lights
- Incandescent Light
- 8L x 3W Inch
- Amber
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: LED Combination Trailer Tail Lights - Submersible - Driver and Passenger Side - 25' Wire Harness
- Shop: Combination LED Trailer Tail Light - Submersible - 6 Function - 11 Diodes - Passenger Side
- Search Results: conspicuity tape
- Search Results: reflectors
- Shop: Trailer Wiring
- Article: Trailer Lighting Requirements
- Shop: Thinline LED Clearance and Side Marker Light - Submersible - 3 Diodes - Rectangle - Amber
- Video: A Closer Look at the LED Combination Trailer Tail Lights
- Shop: Peterson LED Identification Light Bar - Submersible - 6 Diodes - Stainless Steel Base - Red Lens
- Shop: 16-14 Gauge Butt Connector - 5 Pack
- Shop: Combination LED Trailer Tail Light - Submersible - 7 Function - 14 Diodes - Driver Side
- Shop: Optronics LED Clearance or Side Marker Light w/ Reflex Reflector - 6 Diodes - Oval - Amber Lens
- Q&A: Do I Need To Ground the Trailer Junction Box If Running a Ground Wire For Each Light To This
- Q&A: Parts Needed to Rewire Vintage Trailer
- Q&A: Installing Trailer Connector and Junction Box on 20ft Gooseneck Trailer
- Video: Trailer Wiring Junction Box Review
- Video: Optronics Rectangular LED Trailer Clearance and Side Marker Light with Reflector Review
- Video: Optronics 7" Long Silver/ 11" Long Red Conspicuity Reflective Tape: The Breakdown
- Video: What to Know About the Thinline LED Clearance and Side Marker Light
- Q&A: Wiring A 2017 Sundowner Livestock Trailer With A 7-Way
- Q&A: How to Rewire an Old Cattle Trailer
- Q&A: What is the Difference Between Over 80 inch and Under 80 inch Trailer Tail Lights
- Q&A: Picture Request for the Snap-On Reflector Ring Installed on a Optronics 6-1/2 inch Oval Light
- Video: Complete Breakdown of the Optronics Fleet LED Trailer Tail Lights w/ Grommets
- Video: Comprehensive Review: LED Clearance or Side Marker Trailer Light w/ Reflector



