Wiring A 2017 Sundowner Livestock Trailer With A 7-Way
Updated 02/17/2026 | Published 06/12/2024 >
Question:
i have a 2017 sundowner livestock trailer and the 7 pin wiring harness has been disconnected. I am trying to reattach but do not see any harness with all the connections. there is a hopkins engager brake box. where do the wires from the trailer come into the nose of the trailer and come out to reconnect the pig tail
asked by: Kaye T
Expert Reply:
Hello Kaye, thanks for reaching out. We do not have any schematics or anything we can reference to tell us where exactly the factory wiring harness comes out of the frame. I did see a few pictures online that showed the wiring harness coming down from the driver's side of the gooseneck tube. With someone having removed it, there is no way of knowing what, or how much, of the wiring was removed. If it were me, I would start at the back of the trailer and trace the wires as far forward as I can. Same with the brake wires. Just follow them forward and see where they go. Depending on how that goes, the best option may be to completely re-wire the trailer with a &-way plug and lead like part # 50-67-106.
Continue Researching
- Shop: Trailer Wiring
- Article: Trailer Lighting Requirements
- Search Results: conspicuity tape
- Search Results: reflectors
- Shop: LED Combination Trailer Tail Lights - Submersible - Driver and Passenger Side - 25' Wire Harness
- Shop: Combination LED Trailer Tail Light - Submersible - 6 Function - 11 Diodes - Passenger Side
- Q&A: Replacing Lights and Trailer Connector on Boat Trailer Over 80 Inches Wide
- Q&A: Parts Needed to Rewire Vintage Trailer
- Q&A: Do I Need To Ground the Trailer Junction Box If Running a Ground Wire For Each Light To This
- Q&A: Installing Trailer Connector and Junction Box on 20ft Gooseneck Trailer
- Shop: Thinline LED Clearance and Side Marker Light - Submersible - 3 Diodes - Rectangle - Amber
- Video: A Closer Look at the LED Combination Trailer Tail Lights
- Shop: Combination LED Trailer Tail Light - Submersible - 7 Function - 14 Diodes - Driver Side
- Shop: Peterson LED Identification Light Bar - Submersible - 6 Diodes - Stainless Steel Base - Red Lens
- Shop: Optronics LED Clearance or Side Marker Light w/ Reflex Reflector - 6 Diodes - Oval - Amber Lens
- Shop: 16-14 Gauge Butt Connector - 5 Pack
- Video: Optronics Rectangular LED Trailer Clearance and Side Marker Light with Reflector Review
- Video: Trailer Wiring Junction Box Review
- Video: Optronics 7" Long Silver/ 11" Long Red Conspicuity Reflective Tape: The Breakdown
- Q&A: Installation of Optronics Sealed, 6-1/2 Inch Oval LED Trailer Stop, Turn, and Tail Light
- Q&A: Picture Request for the Snap-On Reflector Ring Installed on a Optronics 6-1/2 inch Oval Light
- Q&A: Recommended Lights for 28 Foot Gooseneck Horse Trailer
- Video: What to Know About the Thinline LED Clearance and Side Marker Light
- Video: Review of the Snap-on Reflector Ring for Flange or Surface Mount Trailer Lights
- Video: Optronics Trailer Lights A65PB Review
- Article: Trailer Wiring Diagrams

Jesse M.
2/17/2026
Hey Kaye, what ended up happening when you traced the wiring on your Sundowner trailer? Were you able to locate where the harness comes out or decide to rewire it with the new 7-way plug and cable? Your update could make it easier for others working on similar trailers.