Can Curt Weight Distribution Shank Be Used In Rise Position
Updated 10/27/2025 | Published 03/20/2025
Question:
Hello, I was wondering if I can flip the CURT 17132 hitch upside down to use as a “rise” hitch? I have a husky centerline attached to it. I just purchased a new toy hauler, and it sits nose down behind my truck. I just want to make sure that it is safe to mount the CURT 17132 upside down sticking up to produce a rise as my truck is a little low in the rear. Thank you!
asked by: Josh B
Expert Reply:
Hey Josh! Yes, it is perfectly acceptable to use the Curt Weight Distribution Shank # C17132 in the rise position as seen in the attached photo. If you have any other questions don't hesitate to reach out in the comments below.
(click to enlarge)
Product Page this Question was Asked From
Curt Weight Distribution Shank for 2.5" Hitches - 9-1/4" or 10" Drop - 13" Rise
- Accessories and Parts
- Weight Distribution Hitch
- Shanks
- 1400 lbs TW
- Fits 2-1/2 Inch Hitch
- Round - 10 Inch Drop
- Trunnion - 9 Inch Drop
- Round - 13 Inch Rise
- Trunnion - 13 Inch Rise
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Best Weight Distribution Shank for a 2018 Ram 2500
- Q&A: Dimensions Of Curt Weight Distribution Shank C17132
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Do You Carry A Replacement Flush Valve For My Thetford Toilet?
- Q&A: Choosing Correct Weight Distribution Shank
- Q&A: Lock Recommendation for Bulletproof Adjustable Ball Mount for 2.5 inch Hitch
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: 2-1/2 Inch Shank for Eaz-Lift Weight Distribution Hitch
- Q&A: Is Curt Weight Distribution Shank Compatible with Equalizer Weight Distribution Shanks
- Article: Anti-Rattle Devices
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Big Truck Big RV
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Is It Illegal to Leave My Hitch on My Truck?
Robin H.
10/27/2025
Hey Josh, how did things go using the Curt weight distribution shank in the rise position with your toy hauler? It’d be great to hear if that helped level out your setup. Your update could make it easier for the next person with the same issue.