What Hanger Kit To Use For Tandem Axle Trailer With 2,000 lb Axles
Updated 10/27/2025 | Published 03/05/2025
Products Featured in This Question
Question:
Im building a 20ft tounge to back tandem axle trailer with 2000 pound axles and am going to use these 26” springs. My question is which hanger kit do I need? They all have different length brackets and I’m not sure what my best option is.
asked by: Torrey
Expert Reply:
Hello Torrey, thanks for reaching out. Generally with a 2,000 lb axle setup you would want each hanger to be the same height. Using a taller hanger will increase the deck height, and shorter hangers will bring it lower. So if you want a lower ride, you could use a kit like the # APT9 kit which comes with 2-1/2" tall hangers. Or to bring it higher use # APT5 which is 3-1/4" tall hangers. This could also help get you more clearance between the tires and fenders if needed.
I have linked a few articles for you below. One goes over the basics of double-eye leaf spring suspension, and the other will show you how to determine your axle placement.
Leave a reply below with any other questions or comments and I will get back to you.
(click to enlarge)
Product Page this Question was Asked From
4-Leaf Double-Eye Spring for 2,000-lb Trailer Axles - 26" Long
- Trailer Leaf Springs
- Double Eye Springs
- 9/16 Inch Eye
- Nylon Bushings
- 2000 lbs
- 1-3/4 Inch Wide
- 4 Leaf
- 26 Inch Long
- Standard Grade
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: 2,000 lb Axle Leaf Spring Recommendation for Trailer that has 26-1/4 inch Long Springs
- Q&A: Leaf Spring Recommendation for 1996 Calkins Boat Trailer
- Article: How to Raise Your Travel Trailer Height
- Q&A: Recommended Shackle Straps and X-Factor Crossmember Compatible w/ MORryde ALLTREK 4000 Equalizers
- Article: Where to Position the Trailer Axle?
- Q&A: Do You Have an Axle for My Smoker Hub Face 52" and Spring Center 43", 5 on 4 1/2" Bolt Pattern?
- Q&A: Replacement Wheel Stud that is .545 Diameter and 1/2 - 20
- Q&A: Raising Trailer Suspension To Clear Rear Leaf Spring From Hitting The Crossmember
- Q&A: What Is The Difference Between The etrailer e54SR And Dexter DX23CR Leaf Springs?
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Replace Trailer Leaf Springs in 5 Steps
Jesse M.
10/27/2025
Hey Torrey, how did the hanger kit work out with your 26-inch springs on the tandem axle trailer? Did the 2-1/2 inch hangers give you the deck height you wanted? Your update could make it easier for others building a similar setup.