What Shaft Does Trailer Ramp Spring part # M366FR Fit Onto
Updated 10/30/2025 | Published 02/23/2025
Question:
I am looking for a 1 1/2 inch shaft to fit the springs you sell .
asked by: Jerry O
0
Expert Reply:
Hey Jerry, we don't sell the 1-1/2 inch diameter shafts that the Ramp Spring part # M366FR fits onto. That's usually found on the trailer already. Are you fabbing something up on your trailer?
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Ramp Spring - 2K Torque for 1-1/2" Shaft - RH
- Trailer Ramp Springs
- Single Ramp Spring
- Coil Spring
- M-3 and Associates
more information >
Continue Researching
- Shop: Brophy Rope Ring Tie-Down Anchor with Plastic Pan - Bolt-On - Surface Mount - 1,000 lbs
- Search Results: trailer ramp springs
- Search Results: karavan
- Shop: Ramp Spring - 2K Torque for 1-1/2" Shaft - RH
- Video: Review of M-3 and Associates Trailer Ramp Springs - Single Ramp Spring - M366FR
- Search Results: d ring
- Video: All You Need to Know About the Brophy Rope Ring Tie-Down Anchor with Plastic Pan
- Q&A: Size of the Mounting Hole of the Brophy Rope Ring Tie-Down Anchor # RR09
- Q&A: Overall Diameter of Brophy Rope Ring Tie-Down Anchor # RR09
- Shop: Brophy Rope D-Ring Tie-Down Anchor - Bolt-On - Surface Mount - 1,500 lbs
- Shop: Let's Go Aero D-Ring Tie-Down Anchors for Cargo Carriers - Bolt On - 800 lbs - Qty 4
- Q&A: Replacement Bushing For Dexter 5-Leaf 10,000 Pound Axle Slipper Spring DX45QR
- Q&A: Specs for the Dexter 5-Leaf Slipper Spring W/ Flat End for 10K Axles
- Q&A: Replacing Ramp Springs On Featherlite Snowmobile Trailer
- Q&A: Choosing the Correct Replacement Spring for an Enclosed Trailer Ramp Door
- Q&A: Availaiblity of White Half Moon Trailer Vent
- Article: Trailer Wiring Diagrams
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How Level Should a Tow Bar Be When Flat Towing
Jameson C.
10/30/2025
Hey Jerry, did you end up finding a 1-1/2 inch shaft that works with the ramp spring? Knowing what you used could help others trying to match the same setup.