Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Replace your trailer ramp spring with this steel alloy spring. Ramp door spring lets you easily lift and lower the ramp or door on your enclosed trailer.
Note: The bars need to be mounted flat to the surface on which they are being used.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everyone, Steven here with etrailer.com. Today we're looking at this ramp spring rated at 2,000 pounds of torque for 1-1/2-inch shaft on the right-hand side. So it's very important, this is a right-hand spring. As you can see, it has a green paint on it, that indicates the right hand, and that's the orientation that you should be looking at from your angle. So when this is installed on the right-hand side of either ramp, on your ramp spring set, this will be the right-hand side. So, throwing up a picture here of both springs.
On that photo, this is the left ramp on that trailer, but yet the right-hand spring would go on the right-hand side there. So keep in mind the orientation of this spring we're looking at and those images to make sure you're ordering the correct one. So if you don't order the correct one, unfortunately, it's not going to open or close the way you need it to. So be safe. These are under immense pressure once you get them installed, as you probably already know, but I always like to point it out.
So these are going to provide approximately 90 degrees of deflection. And they are coiled up, as you can see. The width of this coil is 2-1/2 inches, and the length overall is 3-3/4 inches. The overall length tip to tip is about 10 inches. And the inner diameter of this coil, it's going to fit a 1-1/2-inch shaft.
Now, the bars need to be mounted flat to the surface on which they're being used. So make sure, again, you're looking at the orientation and you're getting these installed correctly. Now, this, again, is the right hand assembly, if you need the left hand, we carry that here separately as well. Well, folks, I think that's going to wrap it up for our quick look together. I'm Steven, as always, please, we'd love to hear your feedback on the products here at etrailer.com.
Send us photos, videos, feedback, good or bad, whatever you personally think about the product, let us know. Have a good one.
Good quality and and work great
Great fast service and affordable!
Great quality.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Brooke M.
4/13/2025
Happy to hear that, James! Now you and your trailer can spring back into action with the new replacement ;)