Do I Need Spacers to Install Air Bags on a 2021 Ford F-150 Tremor?

Question

Question:

I have 21 F-150 Tremor looking to get these ultimate 5000s with the cradles, do I need any spacers at all?

asked by: Dan

0

Expert Reply:

Hey Dan! It looks like the lift in the back of the 2021 Ford F-150 Tremor only has a 2" lifting block. You will not need any spacers to install the Air Lift LoadLifter 5000 Ultimate Air Helper Springs item # AL54JQ.

expert reply by: Jerred H

0

Dan

1/2/2025

Hey Jared sorry I have 2.5 tappered rear blocks will that make any difference just in case it a 21 F-150 Tremor. Thanks Dan

Jerred H.

1/2/2025

@Dan That changes my answer! You will want the Air Lift Universal Air Spring Spacers for LoadLifter 5000 and 7500XL item # AL52420.

Dan

1/2/2025

Hey sorry all the questions just to be sure so since I have a 1/2" taller rear blocks I will need those 2" spacers? I just ro have everything before I install so I'm not waiting for stuff appreciate your time. Thanks Dan

Jerred H.

1/2/2025

@Dan Yes, you do! You can get away with a 1"- 2" but any larger and you would be limiting the range of movement in your suspension.

See All (7) Replies to Dan ∨

Answer 1

Chris, good question. A 35K BTU furnace will heat a 24-footer quickly, but that’s not necessarily a bad thing - short run cycles save propane. The only time “too much” heat is a factor is if your ducting can’t move the air fast enough, which can lead…

view full answer...

Answer 2

Hello Thomas, Definitely happy to get the parts you need. Looks like you already found the bags—the Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers - Rear Axle #AL67PD will fit your 2022 Ford F-150 4WD as long as it…

view full answer...

Answer 3

Hey Gilbert, The right air spring kit for your 2023 Ford F-150 4WD is going to depend on if your model has Continuously Controlled Damping (CCD) suspension or Onboard Scales option as well as if you have a PowerBoost hybrid engine. If you have CCD…

view full answer...

Answer 4

Hey James, we have compartment latches like you are looking for with the Bauer Products RV Baggage Door Slam Latch part #BA57FR which is designed to fit a cutout of 3-1/4" tall x 4" wide. It's hard to say exactly what you cut out is but…

view full answer...

Answer 5

Yes, you can Bruce! This is a common practice actually. You can use the Air Lift Union Tee for 1/4" Air Lines item #AL21838. This will allow you to fill both bags using a single inflation valve. The Air Lift LoadLifter 5000 Air Helper Springs…

view full answer...

Answer 6

Hey Raymond, since the 5k rated etrailer jack part #e55ZV is rated higher than the 3.5k option you also mentioned it will work a little bit quicker since it won't be working quite as hard. With that said it's not a fast jack by any means. It…

view full answer...

Answer 7

If they were talking about the hub face and spring center measurements then what was referred to was the hub-face-to-hub-face and spring-center-to-spring-center lengths. Hub face is measured from the base of one wheel stud to the base of the wheel…

view full answer...

Answer 8

Hello Nathaniel, thanks for reaching out. So the etrailer jacks are going to be a great choice from a durability and affordability standpoint. The jacks offer all of the features you would want like a work light, sealed switches and a manual crank…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Do I Need Spacers to Install Air Bags on a 2021 Ford F-150 Tremor?

Product Page this Question was Asked From

Continue Researching