Power Requirements for Dometic RV Furnace - LP Gas - Automatic Pilot - 12V DC - 25,000 Btu
Updated 11/17/2025 | Published 11/30/2024
Products Featured in This Question
Question:
What is the power requirements of the 120 to 12 volt converter that is needed to operate your 12volt furnaces and do you have a recommendation of a power supply to purchase.
asked by: Steve B
Expert Reply:
Hi Steve; the requirements vary depending on the model but the # DMC94RR uses 12V power with an amperage of 7.5A. Your converter only needs to be able to handle the 7.5 amp draw from the furnace. The smallest we have is a converter charger like the # PD49RR which is 30A but you're going to need a battery to go with it. Alternatively you could add a full power center like # PD4045KA. The converter output is quite a bit higher compared to your requirement but that gives you room to add something later like lights.
Product Page this Question was Asked From
Dometic RV Furnace - Propane - Automatic Pilot - 12V DC - 25,000 Btu - Doorless
- RV Furnace
- Doorless
- 5th Wheel
- Motorhome
- Travel Trailer
- 25000 Btu
- 16-1/2W x 7T x 20D Inch
- Dometic
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: rv sewer hose fittings
- Search Results: rv water pump accessories and parts
- Search Results: rv water pump
- Video: Complete Breakdown of the Seaflo Diaphragm Pump for Boats and RVs
- Shop: Trailer Wiring
- Shop: Camco Low-Pressure LP Gas Regulator w/ 12' Long Hose
- Shop: Propane Hose - 3/8" Female SAE Swivel x 3/8" Female SAE Swivel - 4'
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Seaflo Diaphragm Pump for Boats and RVs - Variable Flow - 3 GPM - 45 psi - 12V DC
- Search Results: battery disconnect
- Shop: Bulldog Winch 500 Amp Shut-Off Switch - Metal Housing
- Shop: Seaflo Battery Disconnect Switch for Boats and RVs - On/Off - 900 Amps
- Shop: Seaflo Battery Selector Switch for Boats and RVs - 6V, 12V, 24V, and 32V
- Q&A: Exact Size Furnace Replacement Recommendation for Atwood 8531
- Q&A: Replacement Dometic 942 Furnace For 2020 RV Travel Trailer
- Q&A: Replacement for a Atwood AFMD35131 Furnace
- Q&A: Looking For Furnace To Replace Hydro Flame Model 8241 In 1989 Teton 5th Wheel
- Q&A: RV Furnace Recommendation to Replace Atwood 2334DCLP
- Q&A: Availability of RV Furnace that Can be Mounted Vertically
- Q&A: What Is The Difference Between Dometic RV Furnace 12V DMC64MR And DMC99MR ?
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
Robin H.
11/17/2025
Hey Steve, how did things go with the converter setup for your 12V furnace? Did the 30A converter or the full power center end up being the better fit for your needs? Your update could make it easier for the next person with the same question.