Will Firestone Air Springs Fit 2019 Toyota 4Runner With Lift

Question

Question:

I have a 2019 4Runner without KDSS, and a 2 lift front and rear. Will the Firestone air springs work with this setup? If not, do you carry a set of air springs that will work? Thank you.

asked by: Ed M

0

Expert Reply:

Hi Ed,

So long as the coil springs on your 2019 Toyota 4Runner remain the stock size, the Firestone Coil-Rite Air Helper Springs # F4135 will fit.

They'll still give you excellent support for your 4Runner's rear suspension as you're towing or even just have a heavy load in the back.

expert reply by: Kyle S

0

Ed M.

10/3/2024

Hi Kyle, I don't think I was clear. The 4Runner has a 2" lift, front and rear. The rear springs are a bit longer than stock (hence the lift).

Kyle S.

10/3/2024

@EdM Are the coil springs the same width overall? It's fine if they're longer by a couple inches, but the coil springs do need to be the same width for the springs to work. If they're not the same width there aren't going to be any air springs, and the only option would really be the Timbren Rear Suspension Enhancement System # TTORSEQ and two per side of the Timbren 1" Spacer For Raised Frame Vehicles # TA25723-90AD00.

Ed M.

10/3/2024

@KyleS Thank you, Kyle. Now I know what to look at. I'll get some measurements and figure out which system will do the trick. I really appreciate your patience and help and again I apologize for not being clear in the first place! Ed

Answer 1

There should be enough free play in the shackles to allow them to move. There is no specific torque rating for shackle bolts. The first thing you should make sure of is that the bolts you use are long enough so that when installed you will have at…

view full answer...

Answer 2

Hey Anthony, you would want the Sumosprings kit part #SS68DR that is a confirmed fit for your 2020 Toyota 4Runner and then since you have a 3 inch lift you'd need a quantity of 6 of the spacers #A25723-90AH00 to take up that extra space created.…

view full answer...

Answer 3

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Answer 4

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 5

If you didn't change out the coil springs then the #F4135 will work fine with your 2021 Toyota 4Runner. If you did change out the factory springs to a different spring that has a different diameter then I am going to need to know the inside…

view full answer...

Answer 6

The BTR and BT8 denotations refer to the spindle, not the trailer hub. The difference between a BTR and BT8 spindle is that the BTR spindle uses a 1.063" diameter L44649 bearing and the BT8 spindle uses a 0.99" diameter L44643 bearing. In…

view full answer...

Answer 7

If you are considering Timbrens like the #TDR1500DQ and the SumoSprings like the #SSR-307-47 for your 2022 Ram 1500 4x4, I recommend the SumoSprings #SSR-307-47. The SumoSprings will offer the same quality as the Timbrens in terms of suspension…

view full answer...

Answer 8

Hey Lynn, we generally don't recommend running more than one set of suspension enhancement on a vehicle because the performance of the two kits together has never been tested and most likely if you need two you are overloading things. I would…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Will Firestone Air Springs Fit 2019 Toyota 4Runner With Lift

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching