Replacement Hub for a Hub Stamped H1000 R
Updated 08/12/2024 | Published 08/09/2024
Products Featured in This Question
Question:
I have a boat trailer with a hub stamped H1000 R and 127 on the back. It’s 5x4.5 patterned. Looking for entire hub replacement kit, ideally progressed. The spindle is tapered and I believe the trailer is 3500lb.
asked by: Jason R
(click to enlarge)
(click to enlarge)
Expert Reply:
Thanks for the pictures! I would be happy to help you find the correct replacement hub for your trailer, but I need some more information. You will need to determine which inner and outer bearings your spindle uses as I was unable to find any information on a specific replacement hub for you and I can not tell from the pictures.
The easiest way would be for you to check the bearings for part numbers. If your bearings are worn to the point that you cannot read the bearing numbers you will need to use digital calipers like item # PTW80157 to precisely measure your spindle according to the included diagram.
If you could comment below with the bearing numbers or spindle measurements I would be happy to recommend a replacement hub for you.
(click to enlarge)
Product Page this Question was Asked From
Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- Bearing Kits
- Bearing L44649 and L68149
- Race L68111 and L44610
- 3500 lbs Axle
- etrailer
more information >
Continue Researching
- Video: Review of Dexter Trailer Bearings Races Seals Caps - Bearing Kit 3500LB Axle - DX76ER
- Search Results: h~1000
- Search Results: bearing
- Shop: Dexter Bearing Kit for 1-1/16" to 1-3/8" Tapered Spindle
- Shop: Dexter Bearing Kit for 4.4K Axles - Inner and Outer Bearings LM67048/L68149
- Shop: 4-Leaf Slipper Spring w/ Radius End for 2,000-lb Trailer Axles - 24-1/4" Long
- Search Results: trailer suspension parts
- Search Results: bk2~100
- Shop: 4-Leaf Slipper Spring w/ Flat End for 3,700-lb Trailer Axles - 30" Long
- Shop: Single-Axle Trailer Hanger Kit for 1-3/4" Slipper Springs - 1-1/2" Tall Front
- Shop: 4-Leaf Slipper Spring w/ Radius End for 2,000-lb Trailer Axles - 24-5/8" Long
- Shop: Rear Hanger for 1-3/4" Slipper Spring
- Q&A: Where Should Rear Hanger Location be for Slipper Springs
- Q&A: Replacement Hub for a UFP H-1377 on a 2004 Tahoe Boat Trailer
- Q&A: How to Determine Correct Replacement For UFP H1377 Hub
- Q&A: Replacement Bearing Kit for Reliable Brand H-1000 Series Hub
- Q&A: What Is The Difference In A Grease Seal Labeled 171255TB and A Seal Labeled 171255VB
- Q&A: Replacement Grease Seal for Timken 171255
- Q&A: What is Next Size Smaller Bearing Buddy than One with 1.98 inch Outer Diameter