What Can Be Used To Mount Wires For An LED Light Strip On A Camper Shell Roof
Updated 01/19/2026 | Published 07/30/2024
Products Featured in This Question
Question:
what kind of fastner do i use for attaching wires to my camper shell roof... when i install the LED strip?
asked by: Gary
0
Expert Reply:
Hey Gary,
I typically use a zip tie mount to hold the wiring up to avoid having to drill into the shell. You can get these at your local hardware store and stick them to the wall of the shell and run a zip tie through it to secure the wires. If you don't mind drilling into the shell then you could use a loom clamp like part # SWC9020-1.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
etrailer Rubber Hitch Cover for 2" Trailer Hitches - Qty 1
- Hitch Covers
- Misc Covers
- Plain
- Rubber
- Fits 2 Inch Hitch
- Standard
- Square
- etrailer
more information >
Continue Researching
- Q&A: Does Curt Hitch for 2026 Toyota Corolla Cross Also Fit Hybrid Models
- Q&A: Recommended Hitch for a 2026 Toyota Corolla Cross and How to Install It
- Q&A: Will The etrailer Hitch e83ZR Fit A 2026 Subaru Forester Wilderness?
- Q&A: Recommended Flat Towing Parts for a 2026 Ford Maverick Lariat
- Q&A: Stealth Hitch that Fits 2024 Ford Mustang Mach-E
- Q&A: Why Does the etrailer Trailer Hitch part # e72AR Have a Higher Towing Capacity than the Vehicle?
- Q&A: Best Replacement For Older Dometic Duo Therm 57915.531 Ducted Single Zone AC System With Furnace
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What RV AC Will Work With Your Setup? Avoid Costly Mistakes Before You Order
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Can I Put Wallpaper in My RV?
Robin H.
1/19/2026
Hey Gary, how did the wiring setup for your LED strip on the camper shell roof turn out? Did the zip tie mounts hold everything in place the way you wanted? Your update could make it easier for others working on a similar lighting project.