Replacement Converter Section For Parallax 7345 in Airstream

Question

Question:

This looks like it would fit in the parallax 7345 in my 2006 airstream international 28. The converter I have isn’t charging. Can you confirm?

asked by: Jeff N

0

Expert Reply:

Hey Jeff,

We do have the right replacement converter section for your Parallax model 7345, and what you need is the Progressive Dynamics Replacement Section for AC/DC Power Distribution Panel - 45 Amp # PD4645V.

expert reply by: Kyle S

0

Answer 1

Yes, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers #PD4645V is a replacement for your Parallax Converter 6300 model 6345.

view full answer...

Answer 2

You are correct the 6332 model Magnetek converter is not compatible with Lithium batteries. To upgrade to a lithium battery system you will need to replace the entire power center with the Progressive Dynamics RV Power Control Center item #PD4135K.…

view full answer...

Answer 3

Yes, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 55 Amp, #PD4655V is what you are looking for. This upgrades or replaces the converter section for 55-amp Parallax/Magnetek, WFCO, or Parallax RV power centers and works…

view full answer...

Answer 4

Yes, you certainly can use a converter like the #PD4635V without a battery. Power sources may include, but are not limited to 120VAC shore power, onboard generator or 12VDC battery power.

view full answer...

Answer 5

In nearly every case of a powered jack not working the problem is ground related. See if you can improve the ground of the jack and you should see it start working. Some ground through the mounting hardware so make sure it's connected to a clean…

view full answer...

Answer 6

I believe you meant to say converter, for your Parallax 7300. The correct replacement is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers #PD4645V; this replacement is compatible with your AGM batteries as well. As far as…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 11

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Replacement Converter Section For Parallax 7345 in Airstream

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching