Are There Replacement Parts For Greystone GR54FR

Question

Question:

Can I get replacements parts for my unit. I bought it in may and the heater stopped working wf2613l

asked by: Jim

0

Expert Reply:

Hello Jim,

While there are no replacement parts for the Greystone Fireplace # GR54FR, this unit does have a 1-year warranty against defects so it can be replaced if it simply stopped working after a number of months.

expert reply by: Kyle S

0

Answer 1

Hey Kevin! You'll want to use the included hardware and the pre-drilled holes in the side brackets to install the Greystone RV Fireplace item #GR54FR. I have attached a couple of pictures below that will show you where the hardware installs. We…

view full answer...

Answer 2

The newer Chevrolet and GM pickup trucks have a known power deficiency issue with the Furrion Vision S Wireless RV Observation Camera System w/ Side Marker Light Cameras #FCE48TASL-05. There is likely nothing wrong that you did, the problem is the…

view full answer...

Answer 3

Fireplace manufacturers do not offer replacement parts like the ones that you damaged. Especially since the Greystone fireplace you mentioned was discontinued. It would be a good time to replace what you have with the very similar #GR54FR.

view full answer...

Answer 4

I recommend starting by removing your Greystone RV Curved Electric Fireplace #GR54FR from the wall/cabinet and disconnecting it from its power source. While it's unplugged blow out the vents with a can of compressed air to remove any dust/debris…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 11

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 12

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Are There Replacement Parts For Greystone GR54FR

Product Page this Question was Asked From

Continue Researching