Are There Any Trailer Hubs With A 6 On 5.5 Bolt Pattern That Are 3-3/8" In total Depth
Updated 02/03/2026 | Published 06/24/2024
Products Featured in This Question
Question:
Hello, I have 1984 cox 944 utility trailer. It currently has a 5 lug pattern hub on it. I want to swap to a 6 lug 5.5 tacoma pattern. Inner bearing is L68149, outer bearing is L44649 total hub depth measuring through center is 3 3/8... What spindle type is this? You guys have a hub I think that would work, but want to make sure its compatible with my spindle. Thanks Glenn
asked by: Glenn H
Expert Reply:
Hey Glenn,
We do offer hubs with a 6 on 5.5 bolt pattern that use bearings # L44649 and # L68149 but they're all 4" or larger in depth. I'm not quite sure what spindle was used on your trailer, but I've seen a lot of older boat trailers with shorter spindles so it's most likely something that's been long discontinued. If you're wanting to switch to this bolt pattern then you'll most likely end up having to replace the axle to something a bit more modern. If this is the route you want to take then give our customer service department (1-800-940-8924) a call and they can order an axle for you.
Product Page this Question was Asked From
CE Smith Trailer Idler Hub Assembly w/ Case for 3.5K Axles - 5 on 4-1/2 - Galvanized - Pre-Greased
- Trailer Hubs and Drums
- Idler Hub
- Pre-Greased
- Standard
- L68149 / L44649
- Marine Grade
- For 3500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- CE Smith
more information >
Continue Researching
- Q&A: What is a #84 Spindle and How Do I Know I Have One On My Trailer?
- Article: Most Popular Wheel Bearings
- Q&A: What Type of Grease Comes in CE Smith Trailer Hubs
- Q&A: Looking For Pre-Grease Hub Assembly For 2008 Bear Trailer
- Q&A: Will The Kodiak Disc Brake Kit K2R35DKG Fit The etrailer Hub AKIHUB-545-35-G-K?
- Q&A: Replacement Hub for a Shorelandr Boat Trailer LUV2314LW-03
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: What Kind of Grease is in the Galvanized CE Smith Trailer Idler Hub Assembly CE13515?
- Q&A: Replacement Idler Hub For ShoreLand'r Trailer
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: Trailer Lighting Requirements
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
Jameson C.
2/3/2026
Hey Glenn, were you able to find an axle that worked for your trailer so you could switch to the 6 on 5.5 bolt pattern? Knowing what solution you went with could help others working with older trailer setups.