Spare Integrated Disc Brake Hub For a 2019 ShoreLand'r LUV30BELWMS0-03 Boat Trailer
Updated 02/17/2026 | Published 06/22/2024
Products Featured in This Question
Question:
Hi, I have a 2019 shorelander V30BLW single axle trailer with surge brakes, vine 1MDAJAU18KA655680. I am looking for a spare integrated disc hub for it. Can you help point me in the right direction?
asked by: Andrew K
Expert Reply:
Thank you for providing your VIN Andrew as ShoreLand'r is one of the few manufacturers who allows us to lookup their parts off a VIN. I see you will need the Disc/Hub # KHR10D, Inner Bearing # L68149, Outer Bearing # L44649 and the Grease Seal Set # BB60002. Do note this seal is slightly different than the one from ShoreLand'r so you will also need to use the new sleeves in the seal set. If you are unable to reuse the Bearing Buddy Protectors # BB1980A-SS you will need a set for the new disc/hub.
Product Page this Question was Asked From
Kodiak 10" Hub-and-Rotor Assembly - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Trailer Hubs and Drums
- Hub with Rotor
- Standard
- L68149 / L44649
- Marine Grade
- For 3500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Kodiak
more information >
Continue Researching
- Q&A: Replacement Bearing Kit for 3,500 lb Axle on Shorelander Trailer
- Q&A: Replacement Hub/Rotor and Bearings for Tie Down Engineering TDE46245
- Q&A: Idler Hub To Replace TDE 46245 Hub and Rotor On Boat Trailer
- Q&A: Replacement Disc Brakes for 2018 Load Rite Boat Trailer With TDE 660
- Q&A: Will Aluminum Hi-Spec Series 04 Star Mag Trailer Wheel # AM20258 Work with ST175/80R13
- Q&A: Replacing Older Tie Down Engineering 46210 and 46845 Trailer Hubs
- Q&A: How to Remove the Outer Brake Pads on the 10" Rotor Kodiak Disc Brake Kit K2R35S
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Best Boat Trailer Jacks
- Article: Trailer Wiring Diagrams
Jerred H.
2/17/2026
Hey Andrew, how did the new disc and hub setup work out on your ShoreLand’r trailer? Were the bearings and seal set a good match with your existing parts? Your update could make it easier for others working on the same trailer.