Parts Needed to Install Crossbars on Truck Camper Shell with Thule Roof Tracks

Question

Question:

I have a topper on my pick up with a Thule Top Track system already installed. There are no track nuts or any other hardware. What do I need to get it set up with square bars?

asked by: Chuck S

1

Helpful Expert Reply:

To construct a roof rack compatible with the Thule Track system on your camper shell, you'd need the following parts:

Thule Rapid Podium Foot Pack, part # TH460R
Thule Fit Kit for roof rails, part # THKIT3101

Then you need to choose the length of crossbar. I've linked our selection that fit the Rapid Podium foot pack, just choose the appropriate length for your tracks. Or tell me how much space is between the tracks and I'll recommend an appropriate bar length.

I'll link you to some FAQ articles about roof racks and accessories you might be interested in.

expert reply by: Mike L

1

Answer 1

Yeah, that things fun with camper shells. I've got exactly what you need though Lauren. If your Leer XR camper shell does not have tracks installed, I recommend the Rhino-Rack Heavy-Duty Roof Rack for Camper Shells item #Y01-120B with 54"…

view full answer...

Answer 2

To mount feet and crossbars to your Leer truck cap with the Thule Roof Mounted Top Rack System #THTP54, you will need to select the correct length cross bars. The Thule WingBar Evo Crossbars are available in the following lenghts. 43" #TH711120…

view full answer...

Answer 3

The Replacement FootBase for Thule Tracker #753-2149 is what you currently have on the Thule tracks on your Leer shell. This footbase is for the now discontinued Thule Tracker square bar setup. You may be able to piece this system together even…

view full answer...

Answer 4

It looks like we have everything you would need except for one of the washers (washer 951061312). I have listed the parts out below. TK1 Base - Part #753-2149 Cover -- Part #853-7084 M6 x 17 mm Bolt -- Part #924-0617-15 M6 Washer - Part #951061254…

view full answer...

Answer 5

Hello Cynthia, The Replacement FootBase Thule Tracker RoofRack FitKits TK1, TK2, TK6, TK7, TK8, TK9, TK10, TK11, TK12 #753-2149 are not compatible with the Rapid Traverse tower feet. The #753-2149 are solely compatible with the Thule Tracker…

view full answer...

Answer 6

To remove or install the Railing Foot #753-2157-02 from the cross bar you need to push in the gray latch and slide down the black cover identified by the red arrow in the picture attached. This will allow you access to the allen head bolt to loosen…

view full answer...

Answer 7

Hey Steve, so the tracks on the top of your camper shell were designed to fit several roof rack brands but the best option overall and for the money is the Rhino Rack roof rack for camper shell tracks part #Y02-490B-NT as this gives you a higher…

view full answer...

Answer 8

I have the part you need! Since Thule discontinued their old feet that are compatible with the older square crossbars without a bottom channel, Thule doesn't make feet that are compatible. However, Inno uses the same exact square crossbar…

view full answer...

Answer 9

I do have an option for you but the Thule Tracker System you have now has been discontinued and Thule no longer makes parts for this. The tracks can remain on the cap but you will need to replace the fit kit (block with bar) and then add a foot pack…

view full answer...

Answer 10

You're in a tough spot as Thule has basically phased out your entire roof rack setup from the feet, to the bars, and the fit kit. I wish I had something I could offer that was simple and easy but based on your situation I would go with option 4…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Parts Needed to Install Crossbars on Truck Camper Shell with Thule Roof Tracks

Featured Help Information

Miscellaneous Media

Continue Researching