Can the Lippert Center Point Suspension Kit Be Installed on a 2024 Alliance Valor

Question

Question:

Can this be installed on a 2024 Alliance Valor?

asked by: Ed B

0

Expert Reply:

Hey Ed, thanks for reaching out!

The Lippert Center Point # LC1565391 can be installed on your 2024 Alliance Valor but you'll need to verify that it meets the following (found in the installation instructions):

"For a standard installation, the trailer must also be equipped with the standard center hanger shape. The hanger may vary in dimension but it must be sized for a 1 3/4” leaf spring width, be at least 2.5” from the equalizer hole to the top of the hanger and be 3” wide or wider."

If your trailer has a unique suspension then the Center Point can still be used, but you'll need to have a certified installer take care of it for you as there will likely need to be some modifications made to your trailer.

expert reply by: Jon G

0

Answer 1

Hey Chris, the Lippert Center Point part #LC1565391 does lift the trailer suspension 2 inches like we advertise so it will help but I have to mention that towing a fifth wheel with a lifted truck is just super challenging. It's hard to get a…

view full answer...

Answer 2

Typically a Dexter 7k axle will have a diameter of 3 inches and an 8k axle will have a diameter of 3-1/2 inches. The thicker the axle the more weight it can handle. There really isn't an advantage to going with higher capacity leaf springs than…

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 7

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Can the Lippert Center Point Suspension Kit Be Installed on a 2024 Alliance Valor

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching