Recommended Replacement for H78-14 Tires

Question

Question:

What size is a replacement? H78-14 ST

asked by: Molson

0

Expert Reply:

Molson, the H78-14 tire size is equivalent to the ST215/75-14 tire size like the Loadstar ST215/75D14 Bias Trailer Tire # AM1ST90.

expert reply by: Bryce D

0

Molson

4/10/2024

I want a radial tires instead. What would that be?

Bryce D.

4/10/2024

@Molson That would be the Karrier ST215/75R14 Radial Trailer Tire # AM10229 then.

Answer 1

I will be happy to help you set up a new brake system for your Escort Trailer. I'll start from the back and work my way forward. I recommend the etrailer Hydraulic Brake Kit Left/Right Hand item #AKFBBRK-35-D. This is a 3,500 lbs set of brakes…

view full answer...

Answer 2

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 3

It really depends on your setup, if the safety chain loops on your tow vehicle are spaced far apart then you will need more slack to make a tight turn then if they were closer together. What I would recommend you do is connect your trailer to your…

view full answer...

Answer 4

Though we do not have a printable 5 lug bolt pattern sheet I can teach you how to properly measure your rim! Since your rim has 5 bolts you will need to measure from the center of one hole to the farthest edge of either of the two farther holes.…

view full answer...

Answer 5

There are a couple of different size modern equivalents to the 78-14 tire size. But for an H78-14, you would need to use an ST215/75-14, see link. If you just want tires, we have bias tire #AM1ST90 and for a radial we have #AM10229. Make sure not to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Recommended Replacement for H78-14 Tires

Product Page this Question was Asked From

Continue Researching