Determining Replacement Bearings for a 2008 Wolverine 24TACU Trailer
Updated 03/28/2024 | Published 03/19/2024
Question:
I have a 2008 Wolverine 24TACU with the VIN: 5BX5BX2888J027943 and I am looking for 4 new bearings
asked by: Cameron W
Expert Reply:
Hey Cameron, unfortunately all the information the VIN gives me is the year make and model of your trailer so nothing actually pertaining to bearings.
In order to get you the correct replacement bearings, you're going to need to pop your hubs off and remove the existing bearings. From here, there should be a set of numbers stamped to the top of the bearing - this is what I'm going to need.
If you can come back with that info handy, I'd be more than happy to help you out.
Product Page this Question was Asked From
Optronics Fleet LED Trailer Tail Lights w/ Grommets - Stop,Turn,Tail - Submersible - Oval - Qty 2
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Recessed Mount
- Submersible Lights
- LED Light
- 6-1/2L x 2W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Q&A: Hole Size Dimension for Optronics LED Tail Light with Grommet
- Q&A: Replacing Horse Trailer Lights
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: What Wire Gauge Is The TowSmart 16 to 18 Gauge, 4 Conductor Wire?
- Q&A: What Is The Size Of The Oval Cutout On The Dexter Light Box Guard DX99VC?
- Q&A: Is Kenda Karrier KR35 ST205/75R15 Load Range C Or D
- Q&A: Can A Load Range G Tire Be Installed On The Lionshead Aluminum Siberian Trailer Wheel LH78MR?
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Converting Your RV Water Heater to Tankless
Cameron
3/20/2024
I suspected that would be the case but wanted to see if there was any way I could get them to do the job in one go. Thank you