What Is The Wiring Diagram For The SeeLevel Monitor # SE94VR

Question

Question:

I am trying to connect this and have no wiring diagram. I have created my own of what I did, and it’s not working. Do you have a wiring diagram for this? I bought it from etrailer a couple of years ago and have never been able to get it to work.

asked by: Tom H

0

Wiring Diagram
(click to enlarge)

Expert Reply:

Here is the wiring diagram from SeeLevel for the Monitor # SE94VR. I hope this helps you clear things up and get it working.

expert reply by: Bud M

0

Wiring Diagram for SeeLevel Monitor # SE94VR
(click to enlarge)

Wiring Diagram For SeeLevel Monitor # SE94VR
(click to enlarge)

Answer 1

Yes we do carry the SeeLevel 709-2P with our part number #SE94VR. This is just the monitor you are looking for. The part #SE49VR that you mentioned includes the monitor but also sensors.

view full answer...

Answer 2

Hi John, I'm sorry you weren't given a set of instructions to go along with your SeeLevel RV Holding Tank Monitor #SE94VR. I've attached a diagram below showing that the White wire will run to your water pump, Red to your 12v power…

view full answer...

Answer 3

The SeeLeveL RV Holding Tank Monitor #SE94VR shuts off after just a few seconds. If you want to have it stay on you have to double click the tank button of you're wanting on and a small dot will appear next to the percentage. I've attached a…

view full answer...

Answer 4

I reached out to SeeLevel who said the SeeLeveL Sensor for RV Holding Tank Monitor #SE78VR will work on schedule 40 PVC pipe but it has to be at least 3 inches in diameter. They also said didn't specify the exact signal type but said it would not…

view full answer...

Answer 5

Hey Steve, yes the Power Watchdog Surge Protector #HU82VR that you referenced is the most current version.

view full answer...

Answer 6

Hi Steve, I checked with our team that handles this and can confirm the hardwired, 50 amp Power Watchdog Surge Protector with Bluetooth, WiFi, and Emergency Shut Down #HU82VR is the Gen II version.

view full answer...

Answer 7

With your trailer not currently measuring propane levels, I would recommend going with the SeeLeveL RV Holding Tank Monitoring System #SE39VR which comes with the water pump switch. The reason for that is because the SeeLeveL RV Holding Tank…

view full answer...

Answer 8

The model number for fans such as the MaxxAir MaxxFan Mini Roof Vent, #MA00-04401M is listed on the upper side of the assembly itself. Please see the attached image. You will best identify this by opening the vent and climbing on top of the RV.…

view full answer...

Answer 9

Hey Robert, The Power Watchdog Surge Protector #HU82VR can be installed on the shore power lines before the transfer switch. Since it's before the transfer switch it would only be tied to the shore power and wouldn't be an issue with the…

view full answer...

Answer 10

You will want to find lights that match the lights you currently have on your trailer. If you have incandescent lights I recommend either staying with incandescent or swapping out all of the lights to LEDs. LED lights draw much less power, so you may…

view full answer...

Answer 11

With plywood walls that are as thin as yours, it's possible that they may not support what you are looking to do. The only way you will be able to utilize the Erickson Horizontal E-Track #EM59150 (2 feet) or #E19148 (5 feet) is by installing it…

view full answer...

What Is The Wiring Diagram For The SeeLevel Monitor # SE94VR

Product Page this Question was Asked From

Continue Researching