Parts Needed To Install 5 On 5-1/2" Bolt Pattern Hubs On a 1987 M105A2 Trailer

Updated 03/12/2024 | Published 03/10/2024

Products Featured in This Question

#84 E-Z Lube Spindle w/ Brake Flange for 3,500-lb Trailer Axles

(187)

$42.79

Dexter Nev-R-Adjust Electric Trailer Brakes - 10" - Left/Right Hand Assemblies - 3.5K

(1845)

$215.32

Junction Box and Installation Kit for Autowbrake Trailer-Mounted Electric Brake Controller

(27)

$39.32

Bright Way Trailer Breakaway Kit with Charger, LED Tester, and 5 Ah Battery - Side Load

(476)

$63.87

Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles - 10" - 5 on 5-1/2 - Pre-Greased

(1943)

$82.56

Question:

I have a 2008 jeep wrangler 2 door on 4 inch taraflex lift I just bought a 1987 m105a2 trailer I wont to bould a overland trailer that is level with my jeep running the same tires and rims I believe it 5 on 5.5 on the jeep I have a picture of the set up before I put the lift on the jeep

asked by: Kevin F

Jeep Wrangler With M105A2 Military Trailer
(click to enlarge)

Expert Reply:

To be able to run the same 5 on 5-1/2" bolt pattern for your Jeep Wrangler on the M105A2 trailer you are going to have to cut off your current spindles to have 2 Spindles # TRU77FR installed. This is the common size spindle found on a 3,500lb axle which will then let you install 2 of the Hub/Drums # AKHD-555-35-EZ-K. With these you will want to install Electric Brakes # 23-468-469 since they are much better on an Overlanding trailer than surge type brakes. We do have a Junction Box # 3430001-JBK and Trailer Breakaway Kit # 3802346 to help with the electric conversion for the trailer.

Please let me know if you need any help finding the wiring parts for your Jeep if you do not already have a 7-way or controller.

expert reply by: Bud M

Kevin

3/11/2024

I was wanting to go with axeless setup for independent suspension I just don't know now if I bought the right trailer do to weight I'm stripping the trailer down to frame and bed to reduce weight I'm just not sure if it will be enough

Bud M.

3/12/2024

@Kevin I completely understand your concern with weight since you are pulling with a Jeep. We do have the Timbren Axle-Less kits which would work in the following drop/rise spindles. 4" Drop # ASR3500S04 No Drop/Rise # ASR3500S05 4" Lift # ASR3500S06 These will all use the brakes and hubs from above as they have the 3,500lb spindle.