Recommended Suspension Enhancement for a 2006 Workhorse W42

Question

Question:

Hello I have a 2006 Workhorse w42 im looking to add air bags to the rear suspension and was wondering if you sell a kit for it

asked by: Adam M

0

Expert Reply:

Adam, we don't have any air springs unfortunately for your 2006 Workhorse W42, but we do have the Timbren Rear Suspension Enhancement System # TGMRP30.

These are hollow rubber springs that sit above the rear axle, has up to 6,000 lbs of capacity, and requires no drilling for installation.

expert reply by: Bryce D

0

Answer 1

I do have suspension enhancement options for a 2002 Workhorse P42 Chassis but there are no air bags available unfortunately. Instead, you can use the Timbren Rear Suspension Enhancement System. The correct one will be based off the suspension. The…

view full answer...

Answer 2

I have a great solution for you that will not require you to lift your food truck. I recommend the Timbren Rear Suspension Enhancement System item #TWRW22.These hollow rubber springs have an 8,600 lbs capacity and sit above the rear axle to help…

view full answer...

Answer 3

For the Workhorse W42 chassis we have the Timbren rear suspension kit part #TGMRP30 but we don't have any air spring solutions. The Timbren kits offer the same support without requiring you to worry about air pressure and leaks though.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 6

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 7

According to my research, your 2001 Airstream Land Yacht 30 is on a P-30 Workhorse Chassis. If this is the case then I do have an option for you but SuperSprings does not offer a set SumoSprings Solo Custom Helper Springs that will work on the front…

view full answer...

Answer 8

Thanks for the picture and dimensions. Based on that the replacement lens you need is the part #MC48AB. This is 2 inch by 4 inch.

view full answer...

Answer 9

Hey Robert! You can install the MaxxFan Dome Roof Vent #MA00-03812B on your wall without the rain shield. However, I would try to add it if possible. This will help keep out water and debris regardless of whether or not you open it in the rain. Also,…

view full answer...

Answer 10

Yes, the bayonet fitting of the part #CAM39863 that you referenced will fit the bayonet style fitting of the #CAM39761.

view full answer...

Answer 11

The Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2" #14053 is a confirmed fit for the Ford Full Size Van but it is not a fit for a cab and chassis like you have which has a slightly wider frame. My recommendation due to the weight you…

view full answer...

Recommended Suspension Enhancement for a 2006 Workhorse W42

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching