Replacement Pin for Legs on Lippert Solid Step

Question

Question:

Lippert Components 678031 i need the pull pins on the slide legs of the bottom of the step

asked by: CLINTON V

0

Expert Reply:

The replacement clevis pin for the leg extension on the Lippert SolidStep # LC791575 is the # LC26AF. This model of the SolidStep replaced your 678031 but the pin is still the same.

expert reply by: Robin H

0

Answer 1

Hey Scott, thanks for reaching out! It sounds like you have a proprietary mounting system so I recommend starting from scratch and either mounting outside steps, like the TorkLift GlowStep Revolution #TLA8103, using the Outrigger Brackets #LC301704,…

view full answer...

Answer 2

The steps are approximately 19.415" in width for the MORryde Flip Tread RV Steps #MR42UR. To get wider steps you would need to size up in mounting width to something like the #MR28RR, but would need to have enough room for the steps to properly…

view full answer...

Answer 3

Hey Joe, so when the Lippert Solidstep part #LC65DX is folded up in the stored position it will take up 10 inches of space inside the doorway of your RV. Do you have any cabinets near the doorway?

view full answer...

Answer 4

For your 2011 Audi Q5 the correct trailer install harness is the part #C59236 that you referenced. Your vehicle has pulse width modulation taillight wiring which is what the Curt harness is designed to work with. The brown wire of this harness (for…

view full answer...

Answer 5

To replace your 57915.331 Dometic Duo-Therm Ac unit, I recommend the Advent Air 13.5K Btu RV Air Conditioner #ACDOM135. This is made to be compatible with your Dometic system, meaning you will not have to change out anything inside the RV. You are…

view full answer...

Answer 6

I recommend replacing your 57915.331 Duo Therm Dometic AC unit with a 13.5K Btu Advent Air AC unit which comes in the following colors: - Black #ACDOM135B - White #ACDOM135 These come with a plug and play wiring harness so the installation is pretty…

view full answer...

Answer 7

We do have some LP gas detectors available, but none would be a direct replacement for your CCI 7770.2 / Pre Tell 22. From what I could find on your CCI 7770.2 / Pre Tell 22, it has dimensions of 6.25" wide x 3.9" tall. The RV Propane Gas…

view full answer...

Answer 8

The closest replacement we have for the Atwood RV Water Heater GE16-EXT is the Atwood RV Water Heater w/ Heat Exchange GCH10A-4E part #AT94023 that we offer. The GCH10A-4E has both gas and electric features just like the GE16-EXT as well as a 10…

view full answer...

Replacement Pin for Legs on Lippert Solid Step

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching