Mud Flaps For a 2024 GMC Sierra 3500 Single Rear Wheel

Question

Question:

Do you have mud flaps for the single rear wheel 24 GMC Sierra 3500?

asked by: BJ

0

Expert Reply:

The WeatherTech Mud Flaps # WT69BV include both the front and rear mud flaps for your 2024 GMC Sierra 3500. The rear are specifically designed with your single rear wheels in mind.

expert reply by: Bud M

0

Answer 1

Hey there, so the rear mudflaps of the Weathertech mudflaps part #WT69BV that you referenced hang down 9 inches from the vehicle and then the front hang down about 8 inches. Would that work?

view full answer...

Answer 2

I'm happy to confirm that the WeatherTech Mud Flaps #WT69BV will fit your 2024 GMC Sierra 2500. These mud flaps are made in the USA, includes 2 front and 2 rear flaps, and has an easy no drill install.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Hi Eric, Thanks for your question. As long as you are able to remove the factory hitch from your 2025 GMC Sierra 2500, the #C96CR will work as a replacement. Of note, the #C96CR will more than likely mount up a bit differently than your factory…

view full answer...

Answer 8

Hi Dennis! The Hellwig Load Pro 35 Heavy Duty Helper Springs with Custom Mounting Kit - Above Axle #HE93XR can potentially raise an unloaded truck a little, but it's going to be very minimal and will really only happen if your suspension is…

view full answer...

Answer 9

Hey Aaron, thanks for reaching out. Based on the specs I found online, the Americana Modular Wheel #AM92NR shares the same dimensions as your SRW 31767A9 trailer wheel. It has the same 17.5" x 6.75" size with 8 on 6.5" bolt pattern and…

view full answer...

Answer 10

Hey Matt, while we haven't had the chance to get a picture of the Curt hitch part #C96CR installed we have had chance with the 2 inch version of the hitch part #C35CR which I attached below. It's on a truck with a service body though so that…

view full answer...

Answer 11

Hey Carter, thanks for reaching out! The GM trucks with the 6-1/2' bed can use a stationary hitch as long as the 5th wheel trailer has a tapered nose. For your 2025 GMC Sierra 2500 I recommend using the PullRite OEX SuperLite #PUL96ZR for a few…

view full answer...

Answer 12

Hey Tim, that's a hard question to give an exact answer on as the Furrion fridge part #FR92TF wouldn't run all the time but it does run more when it is hotter. So it draws around 11 amps when running but it will kick off and on so it's…

view full answer...

Mud Flaps For a 2024 GMC Sierra 3500 Single Rear Wheel

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching