Lift Kit and Wet Bolt Kit for 2019 Dutchmen Voltage 3815

Updated 01/03/2024 | Published 01/02/2024

Products Featured in This Question

Correct Track Trailer Alignment and Lift Kit - Tandem Axle

(55)

$501.83

Dexter Trailer Springs Over-Under Conversion Kit

(821)

$96.36

MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 2-1/4" Long Shackle Straps

(2169)

$125.09

MORryde Suspension Upgrade Kit for Tandem Axle Trailers w Correct Track - 2-1/4" Shackle Straps

(2169)

$147.31

MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 3-1/8" Long Shackle Straps

(2169)

$124.51

MORryde Suspension Upgrade Kit for Tandem Axle Trailers w Correct Track - 3-1/8" Shackle Straps

(2169)

$203.93

Question:

i have a 2019 dutchman voltage 3815 toy hauler tandem axle. i want to know if u make a lift kit to raise rear of vehicle? and a wet bolt kit for leaf spring shackles. it has the moryde equalizer. do u make a heavier duty leaf spring for this unit?

asked by: Chris K

Expert Reply:

We do have what you're looking for, but some more information will be required to find the right parts. If your leaf springs run under your axle you can use a flip kit for a lift. Based on your GVWR I'm assuming you have 6,000 - 7,200 lb axles which would have a 3" diameter. If that is the case, you can use the Dexter Trailer Springs Over-Under Conversion Kit # K71-385-00. This will raise your trailer by the diameter of the axle plus the height of the leaf spring stack.

If your leaf springs are already on top of the axle then you would need the Correct Track Trailer Alignment and Lift Kit # RR23QX you were looking at. This will raise your trailer height by 1-1/4" or 2-1/4" while also keeping your axles aligned. It is also a good option if you want a smaller lift.

For a wet bolt kit I recommend the MORryde Suspension Upgrade Kit. This comes with wet bolts, bronze bushings, and 1/2" thick shackles. The correct kit will depend on the center of hole to center of hole (length) measurement of your current shackle straps. If you have 2-1/4" you need # MR46ZR and for 3-1/8" # MR76ZR. If you end up with the Correct Track installed you would need the # MR58ZR for 2-1/4" and # MR98ZR for 3-1/8".

The only option we might have for a heavier duty leaf spring would be to move up in capacity. I would need to know your axle capacity along with the length of your leaf spring to see if one is available. For your axle capacity I would check the axle tag. For the leaf spring length I have included a helpful article below explaining how to measure. The flat length would be the most accurate since they have likely flattened out over time.