Recommended MoRryde Equalizer and Replacement Shackles for a 2023 CrossRoads Sunset Trailer

Question

Question:

Good afternoon! I was wondering which MORryde Rubber Equalizers and shackle set would fit my 37.5ft 2023 Crossroads Sunset Trail Super Lite 331BH with 2 Dexter D44 axles. Im not sure of the wheel base but the axle weight is 4400 pounds Thank you for your time!

asked by: Keith

0

Expert Reply:

Thanks for the measurements and additional information! To determine which MORryde Equalizer you need you'll want to measure the distance at the bottom of your current equalizers from the center to the center of the bolt holes.

The MORryde item # MR87ZR measures 6-1/2" and is for 33" wheelbases.

The MORryde item # MR27ZR measures 8" and is for 35" wheelbases.

I have linked a couple of diagrams below.

To replace your 2-1/4" shackles, I recommend the MORryde Suspension Upgrade Kit item # MR58ZR.

expert reply by: Jerred H

0

Dimensions Of MORryde Rubber Equalizers # MR27ZR
(click to enlarge)

Dimensions Of MORryde Equalizers # MR87ZR
(click to enlarge)

2023 CrossRoads Sunset Trail Super Lite Travel Trailer
(click to enlarge)

Answer 1

Despite what the manufacturers of these equalizers say, the axle/wheel spacing isn't the right way to figure out the best fit for upgraded equalizers, including the MORryde CRE3000. The wheel spacing is more of a guideline, so to determine the…

view full answer...

Answer 2

I believe you are referencing our 6k double-eye leaf springs, the 4-leaf, 25-1/8" long #e47SR and 5-leaf, 25-1/4" long #e34SR. The number of leaves won't make a huge difference, but fewer leaves can give you a slightly softer ride. So…

view full answer...

Answer 3

As your axles measure 35" apart from center to center but the frame hanger spread (FHS) measured 58-3/4", you did go the correct way. The axle spacing is definitely important, but the FHS is more so. Just be aware that you axle spacing may…

view full answer...

Answer 4

Thanks for the pictures! If you're getting that loud of noise out of your 2019 Jayco Eagle Fifth Wheel's equalizers then it is time to replace them. Greasing them won't fix that loud clunking noise. If your axles are 35" on center…

view full answer...

Answer 5

Thank you for the images. The MORryde Rubber Equalizers #MR87ZR are the correct set for your 2020 Keystone Outback Ultra-Lite 291UBH. You will pair this with the MORryde Suspension Upgrade Kit #MR46ZR. Instead of using the wet bolts included with the…

view full answer...

Answer 6

Yes, axle spread and wheel base by definition are the same measurements. You will measure from the center of one axle to the center of the 2nd axle to determine what you axle spread is. This may be difficult as some wheels and covers will make this…

view full answer...

Answer 7

Thank you so much for all off the information! All of the things you found mean you need the 33" Wheelbase MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR. Since your current leaf springs are 14+ years old that would explain why your…

view full answer...

Answer 8

The MORryde Cushioned Equalizer kit part #MR87ZR is the correct kit for your 2017 Keystone Outback Ultra Lite 278URL based on your axle capacity and wheelbase. Then to compensate for it replacing your shorter width equalizer you'd want to go with…

view full answer...

Answer 9

You will have to do some measuring. Take a look at our Double-Eye Trailer Suspension article (see link). I have also linked a picture of a shackle link showing where to measure. Measurements for replacement 1) Measure current shackle from center of…

view full answer...

Answer 10

I attached a picture that has all of the dimensions of the MORryde SRE3000 part #MR87ZR which would have much better ground clearance than what you have now.

view full answer...

Answer 11

When looking for replacement equalizers axle spread is a guide and will not give you an exact this fits or doesn't. What you'll need to do is measure center to center of the horizontal holes, and from the center of the top hole to the center…

view full answer...

Answer 12

Hi Mike, With the height of your equalizer increasing an inch you might need to switch to 3-1/8" shackle straps #TRSL313 to keep the leaf spring stack level but this isn't an exact science so your leaf springs could end up sitting too close…

view full answer...

Recommended MoRryde Equalizer and Replacement Shackles for a 2023 CrossRoads Sunset Trailer

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching