What is The Height From The Track To The Bottom Of The Roller on E-Track Roller Idler # e67HR?

Question

Question:

For this e-track idle roller # e67HR, what is the measurement for the height of the roller from the e-track? In other words, how far is it from the e-track to where the ratchet strap would go under the roller?

asked by: Randall B

0

Expert Reply:

The etrailer E-Track Roller Idler # e67HR is 3" from the top of the e-track to the bottom of the roller.

expert reply by: Bud M

0

Bob

4/2/2024

Hello Bud Can the end of the strap with the E Track connection fit through the idler. Does the strap have tp be removed from the ratchet and feed through the idler. Thanks Bobby C

Bud M.

4/3/2024

@Bob You will have to remove the strap from the ratchet to get through the idler. The connection end will not fit through the idler slot.

Answer 1

That is a good question, and you will need to use three backing plates for each 5 foot section of e-track, so the exact part you will need is the following: - etrailer E-Track Backing Plates w/ Hardware - Qty 3 #e46RR These will fit perfectly with…

view full answer...

Answer 2

I do have a solution for you, but the 24x60 etrailer Cargo Carrier #e98874 is not designed to be used on the back of an RV. Generally speaking, folding carriers are not ideal because they do not stand up too well to the extra stress exerted by the…

view full answer...

Answer 3

For your 2009 Toyota Highlander Hybrid that has the full size 19 inch spare you'd want the Curt hitch part #13534 as it is the one that fits the best with the large spares like what you have. If you check out the picture I attached you'll see…

view full answer...

Answer 4

I may have a solution for you, but I'm not aware of a 14" trailer tire existing with these specs (Load Range E and 14 ply). The highest rated 205/75r14 tire we have is the Westlake ST205/75R14 Radial Trailer Tire - Load Range D #274-000012…

view full answer...

Answer 5

For your travel trailer tires I recommend going with the pressure found on your tires sidewall. The pressure given on the side of the trailer is for the tires the manufacturer installed on the trailer. If you select a replacement tire which has a…

view full answer...

Answer 6

The typical requirement for a wheel chock is that it's 1/4 of the total diameter of the wheel it's being used on. A 245/45R18 tire has an overall diameter of 26.7 inches so you would need a wheel chock that's at least roughly 6-1/2"…

view full answer...

Answer 7

The Curt cargo carrier part #C18100 is a lighter weight carrier due to it being made mostly out of aluminum. For a lighter weight option for your 2019 Tesla Model X with a hitch like the Draw Tite part #76143 installed this would be a really great…

view full answer...

Answer 8

The only time that sort of width will make a difference is if your tires/wheels are already REALLY close to making contact with your trailer frame. If there are a few inches of clearance then you'll be just fine! For your application I recommend…

view full answer...

Answer 9

For a cargo carrier that you'll be using on the back of a trailer you will need a fixed carrier as opposed to a folding one to have the best stability. There are a couple options for a fixed cargo carrier with a ramp for you. I recommend the…

view full answer...

Answer 10

I'm going to be perfectly honest...the risk is pretty minimal BUT due to the construction differences between bias ply and radial tires the sidewalls do end up flexing differently which could in turn end up with unpredictable ride…

view full answer...

Answer 11

Yes, there is a 225/75R15 trailer tire that will fit a 15" x 5" trailer wheel, which is from Contender: - Load Range D: Provider ST225/75R15 Radial Trailer Tire #TTWTRTM2257515D - Load Range E: Provider ST225/75R15 Radial Trailer Tire…

view full answer...

Answer 12

The 5 means that the wheel is 5 inches wide from bead to bead (not overall width). The J indicates the design of the wheel bead seat but it is nothing you need to be concerned with as this is the most common shape for all trailer tires. To measure…

view full answer...

What is The Height From The Track To The Bottom Of The Roller on E-Track Roller Idler # e67HR?

Product Page this Question was Asked From

Continue Researching