Will Replacement Drop Leg with Foot for etrailer and Ram Square Jacks Fit Shelby Jack
Updated 11/29/2023 | Published 11/28/2023
Question:
Will this leg fit the Shelby 7000 pound capacity trailer jack?
asked by: David C
1
Helpful Expert Reply:
The Replacement Drop Leg with Foot # TJD-7000-FT is designed to fit etrailer and Ram square jacks. Although it is possible it would fit, I don't have any way to confirm this. The best thing you could do is compare the dimensions to your old leg. The tubing dimensions are 2" x 2" and the distance between adjustment pin holes center to center is 3-3/8".
expert reply by:
Robin H
1
Product Page this Question was Asked From
Replacement Drop Leg with Foot for etrailer and Ram Square, Direct Weld Jacks - 7,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Drop Leg
- 2 Inch x 2 Inch Tubing
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What is the Difference Between SuperCrew and SuperCab Ford Truck
- Q&A: Replacing TDE 70LP On Swing Away Tongue
- Q&A: Looking for Replacement Breakaway Battery for Old Battery Break Way Corp 081020FHon Battery
- Q&A: Comparing TruRyde 10-36 Grease and Dexter 10-63 Oil Seal
- Q&A: What is the Correct Replacement Drop Leg for My RAM 8000 Series Trailer Jack
- Q&A: Diameter of the Replacement Footplate Keeper Pin for etrailer and Ram Square, Direct Weld Jacks
- Q&A: Dimensions of MORryde Safe-T-Rail and Short Safe-T-Rail
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Maintenance Schedule
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Big Truck Big RV
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Measure for Trailer Hitch Drop