How To Pair The Wireless Remote to Air Lift WirelessAIR Compressor System # AL74000

Question

Question:

What if ?there is not a yellow wire to ground? My manifold has 3 wires coming out red black and white.,

asked by: Marshall S

0

Expert Reply:

For your Air Lift WirelessAIR Compressor System # AL74000 you will simply need to remove the inline fuse and then wait at least 5 seconds before reinstalling the fuse. The manifold will then go into pairing mode for up to 5 minutes. Then press any button to wake up the wireless controller. It will automatically go to the pairing screen if it is not already paired with a manifold. Use the up and down arrow buttons to navigate the pairing menu. Select the device that matches the manifold serial number located on the side of the manifold.

expert reply by: Bud M

0

Answer 1

Depending on how the Air Lift WirelessAIR Compressor System #AL74000 was installed you may have 1 or 2 fuses you will want to check on your vehicle. The first is a 15 amp fuse where the system attaches to the battery. The 2nd fuse ties into an…

view full answer...

Answer 2

Since the remote on your Air Lift WirelessAIR Compressor System for Air Helper Springs - Remote - Bluetooth #AL74000 was working just fine and then stopped I recommend checking that the ground of the manifold is not underneath the foot of the…

view full answer...

Answer 3

How are you attempting to pair the remote? Are you sure it's not sending just a Fail error code as that's pretty common. We've checked with Air Lift in the past and they've told us the first possible cause might simply be a loose…

view full answer...

Answer 4

In the settings mode of the controller you can join the manifolds with the controller. To set the manifold into join mode locate the yellow join wire. It is the yellow wire with heat shrink on the end of it. Remove the cap leaving it attached to the…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

How To Pair The Wireless Remote to Air Lift WirelessAIR Compressor System # AL74000

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching