Does Key K-127 Fit All Bauer T-Handle Locks

Question

Question:

does one key fit all k127 locks?

asked by: Ted

0

Expert Reply:

Yes, one K-127 key does fit all the K-127 locks from the Bauer Products T-Handle Lock for Truck Caps # BA47VR.

expert reply by: Kyle S

0

Answer 1

The Bauer Products T-Handle Lock for Small Truck Caps #BA97VR comes with the locking T-handle and key, 1 nut, 1 spacer, and the metal latch piece. This handle has a 5/16" square shaft so you would need the corresponding nut and spacer. For a…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

Hello Susan, thanks for reaching out. Yes, we do have a good 12v option for replacing that. Based on the specs I found online, the Dometic DM2672 fridge is a 6 cubic foot unit that measures approximately 54-5/8" tall x 25" wide x 25"…

view full answer...

Answer 4

Hey Daniel! Yes, the Curt Trailer Hitch Receiver #13138, Curt T-Connector Vehicle Wiring Harness #C55384, and etrailer Ball Mount #e67DR are all compatible with each other and are all a fit for your 2005 Ford Ranger XLT. The #13138 is custom fit to…

view full answer...

Answer 5

You can install the Erickson Horizontal E-Track #E19148 in any manner you like, so for a car hauler that has cars of different widths you can place E-track side-by-side, as you can see one of our customers did in the accompanying photo. This E-track…

view full answer...

Answer 6

For a Lippert 4,400 lb trailer axle the correct bearing kit is the part #BK2-100 which includes inner bearing #L68149, inner race #L68111, outer bearing #L44649, outer race #L44610, grease seal #58846, a cotter pin and a tang washer.

view full answer...

Answer 7

Hello Tyler, thanks for reaching out. We may have what you need, but I will need more information in order to know what locks will work. Does your ARE cap use the Bolt brand locks that key to your ignition key? If so, the Replacement Lock Cylinder…

view full answer...

Answer 8

I attached a picture that has about every dimension you could want for the part #BD500217. The overall length is 17 inches and the diameter of the screw is 1-1/4 inches.

view full answer...

Answer 9

Good question; the bolts in the Hardware Kit for Demco Adjustable Channel Mount Couplers #DM6166 should be torqued to 150 lb-ft during install of a Demco coupler like #DM14040-81 to a bracket like #DM66134.

view full answer...

Answer 10

A replacement for your Shelby 5138 is the Fulton Fas-Lok Coupler, 2" Ball, 3" Channel - 3,500 lbs #F223000301. This is a great quality coupler that is cost effective as you referenced. I've attached a review video of this product to…

view full answer...

Answer 11

You'd need to use a Universal Cam for T-Handle or L-Handle #37210925 with the lockable handle like part #37210895 that you referenced.

view full answer...

Does Key K-127 Fit All Bauer T-Handle Locks

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching