RVS Back Up Camera that Can Connect to Female Side of RVS Cable # RVS-885

Question

Question:

Both RVS-776 and RVS-885 are shown as with all female connections, but they are recommended as compatible. Is an adapter included, or in an additional accessory required?

asked by: Brian V

0

Expert Reply:

The RVS camera kit part # RVS-2311 has a matching connector that would fit to the # RVS-885.

expert reply by: Jameson C

0

Answer 1

Yes, we do Brad! The LED Tail Light for RVs Over 80" Wide item #DG52436VP measures 18" long x 1-1/2" wide and has mounting holes 15-7/8" on center. This LED light is sold individually and provides brake, tail, and turn signal…

view full answer...

Answer 2

Hi Lisa; the Rear View Safety Backup Camera #RVS-611-IR is the same as your RVS-MV3-IR. The RVS-MV3-IR replaced the RVS-611-IR and we retained that part number on our site. It still has a 5-pin connector, see the attached photo.

view full answer...

Answer 3

The Jensen RV Stereo #JWM60A would be a great option to replace the Jensen VX4022A that you have. It has all of the same features and then some and fits same double din opening.

view full answer...

Answer 4

Since they are on the same circuit, you will want to switch the running lights to LED as well when installing the #CE44VR. Mixing the two has a tendency to cause problems with the lights functioning, and it is definitely important to have working…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 11

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

RVS Back Up Camera that Can Connect to Female Side of RVS Cable # RVS-885

Products Featured in This Question

Continue Researching